Your cart is empty.
Your cart is empty.Product Description
Features
- Premium material that can avoid pipe cracking and leaking.
- With surface E-coating, the pipe can be more corrosion resistance.
- Designed to match the original part and function, the pipe can fit exactly and perform excellently.
Part Number
This heater pipe is designed to match the original one, so you can make replacement directly as follow part number: 19510-R40-A60, 19510R40A60.
Robert Malerba
Reviewed in the United States on February 3, 2025
I will say I was petrified by the previous reviews that it would leak so I filled it up with some water plugged all the holes with my hands and a Neighbor ‘s hand and pumped air in it to make sure it didn’t leak, it didn’t.I found it to be Very well-made even powder coated all the weldings looked professional. But like some complain, the back bracket wouldn’t line up with the hole so I was able to hold it with a bolt and a washer as seen in the picture. Thank God, the bracket closest to the water pump housing does line up, though I did have to bend the bracket a little bit.To get the old pipe out, I cut it with the saws all about 4 inches from where it went in the housing and then I was able to twist it back-and-forth and pull it up easily. Outside of a small 10 mm bolt bracket with those connectors on it. I fought for 45 minutes, trying to unclip everything until I realized there was a bolt there and that’s all I had to remove to slide all the cables over.When you’re reinstalling and dropping that plume down with the big metal bracket that bolts to the block, make sure you put the heavy wiring harness closest to the block and then the bracket goes over it. I had the wiring harness outside of that plume bracket and I had to undo everything and lift it up and correct it. PIPE I thought it was well made except for the alignment problem, powder coated, seemed to be pretty thick very grateful for the price, got it in one day had it reinstalled within about an hour and a half.Of course, while I was waiting, I took everything apart. I just dropped it right down in the front. Some other people said they put it up from underneath I don’t understand that it was easy to install. Make sure you remove the battery, the airbox, and then any hoses or wires.
Eric Barth
Reviewed in the United States on September 16, 2024
Pipe leaked out of the box. Put my whole job back. Not a great product.
David Bradbury
Reviewed in Canada on September 13, 2024
Installed pipe, filled cooling system , pipe leaked, wife ordered another pipe on her account , this time I pressure tested the pipe no leaks , installed pipe filled cooling system , pipe started leaking as the engine warmed up , so I brazed the first pipe and installed it , good to go ! The pipe leaks where the smaller diameter pipe comes off of the larger pipe right by the thermostat housing ! Poor brazing at manufacturer and obviously no quality control !
Dan D.
Reviewed in the United States on August 29, 2024
ORDERED 2 BOTH ARE LEAKING ON THE WELD WHERE THE SMALL TUBE ATTACHES TO THE BIG ONE
JJ
Reviewed in the United States on November 12, 2024
It works but I could not install both bolts that hold it in place.
Rick Coombs
Reviewed in Canada on April 21, 2024
The same part was on backorder through Honda for triple the price.
Recommended Products