Your cart is empty.
Your cart is empty.Product Description
HECASA Black Driver Seat Switch Bezel Trim Compatible with 09-16 GMC Acadia Chevrolet Traverse Buick Enclave Replacement 25941769
Compatible with
- 2009-2016 GMC Acadia,
- 2017 GMC Acadia Limited Base Sport Utility 4-Door,
- 2009-2017 Chevrolet Traverse,
- 2009-2017 Buick Enclave.
- Replacement for 25941769.
- Made from high quality polypropylene material.
- Durable and precise.
- Instructions NOT included.
- Professional Installation is always recommended.
Chris King
Reviewed in the United States on August 27, 2024
Needed a little modification to fit. Seemed a bit less quality maybe.
Terrence Myster
Reviewed in the United States on June 3, 2024
Had to have my mechanic put is on for me just had to put some strong glue to really hold it in place because of all the sitting i am doing putting pressure on it and it tends to pop out but the glue I used is good
R. Bailey
Reviewed in the United States on October 30, 2024
The trim on the bottom of my driver's seat in my GMC Acadia was all cracked and looked broken and terrible. The dealership wanted a pretty penny for a replacement, so I turned to Amazon. Found EXACTLY what I needed an at a great price. My Acadia looks new again. Thanks!
Dave
Reviewed in the United States on July 5, 2023
I had to reuse the oem rear retainer clip as the one included fell off. It was too big for the round hole in the seat. 1 star deduction for that. Otherwise it was a good install, less than 30 minutes. Loosen the front cover where it meets the side panel you are replacing. The switch panel pops off. Remove 2 screws and the rear clip. Start from the rear for the install. You-tube was a waste of time.
Tripp Skipper
Reviewed in the United States on February 10, 2023
Perfect fit and color match for my 2015 Buick Enclave! There are videos on YouTube that will help with the installation. The one tip that I can give is to pull the trim off the front of the seat when replacing. This made the process way smoother. The front trim is attached to the side and will come off in on piece. Once you have them off you kind of have to twist the two at an odd angle to unlock them from one another. I pretty much had to use the same process in reverse to connect them back together. I'm not sure how others pulled this off without removing the front trim. Once you get the side loose by watching a few videos, just grab the front one side at a time and pull. There are two prongs on each side holding it in place. Don't worry, if you grab firm and close to the prongs as you can, it will not break.
Jessica Shott
Reviewed in the United States on May 4, 2022
Replaced broken one. This replace fit perfect and easy to install.
edgar ross
Reviewed in the United States on March 23, 2022
Fit perfectly
Recommended Products