Your cart is empty.
Your cart is empty. Empi 17-2796 Replacement Outer Conversion Bearing For Empi King Pin Disc Brakes. Allows You To Install Ball Joint Rotors Onto King Pin Spindles.
Bearing Specs:
O.D. 1.570
I.D. .7875
Replacement Bearing Only For Empi Disc Brake Kits Listed Below:
22-2986
22-2990
22-2991
Note: All Bearing Races Must Be Pressed Into Rotors. Any Other Method Can Damage The Rotor And The Bearing.
Eric
Reviewed in the United States on February 3, 2015
Fit fine but.... Had to modify. The edge that goes in when pressed was dead sharp. I had to mill a radius on it in order for it to seat in the bottom. Also it would have been impossible to press in without the sharp edge digging and galling up the walls.
Recommended Products
