Your cart is empty.
Your cart is empty.Product Description
118 degrees split point tip provides faster cutting and prevent sliding while increasing the wear resistance.
Genuine M35 cobalt HSS ensures durability and sharpness which can reduce the friction and run cooler.
The bottom handle of the knife is made of hexagonal handle for more classic durability and non-slip.
Customer
Reviewed in the United States on June 5, 2024
Brocken in 1st use. Shaft brock off
SMc
Reviewed in the United States on June 10, 2024
Everything about this drill bit looks great, however, I gave it an average rating because I have not used it yet.
Audible listener
Reviewed in the United States on November 7, 2024
Great little addition to my tool box
Andrew
Reviewed in the United States on October 20, 2024
Watch your wrist, it wants to rip the drill out of your hand.
MR
Reviewed in the United States on January 4, 2024
very good
Axxinn
Reviewed in the United States on February 26, 2023
Fairly priced tool. for an item that i wont use very often, it work very good.
Jazznupe
Reviewed in the United States on September 20, 2022
Recently I had to add an attachment to the tractor bucket that required 8 holes to be drilled. My plan was to use a bit to get the hole started and then use a step bit to finish the holes. I must say that I began the job without any cutting oil and after about 30 minutes, I only had very hot drill bits, a not so useful step bit that I already owned, and only about a hole and a half completed. I chucked those bits and old step bit and then purchased some new bits and this step bit. A week later, I tried this with cutting oil and the new bits and it did help a lot. I was more able to get the bits to bite and tap the holes and then I used this step bit to finish the hole. However, it was not magic. I still had to work pretty hard, after the first couple of holes which went fairly easy. The next holes got progressively more difficult. In other words, the step bit dulled fast even with a very liberal use of cutting oil. They oil still got hot enough to smoke and the step bit just wasn't grabbing at some points. I tried multiple methods and speeds to get these holes done. I used a lot of oil. So, the step bits worked but not as good as folks were saying they did at least not for me. I would actually rate them a 3.5 if able to give partial stars. Hope that helps.
Hank Virga
Reviewed in the United States on March 6, 2022
Great tool
Recommended Products