Your cart is empty.
Your cart is empty. The lifter allow movement in UP, Down, directions
Positive locking knobs assure rock-steady focus
Suitable for: All DSLR or DC with standard 1/4"" screw hole
Specification:
Material: Aluminum alloy
Weight: 250g
Color: Black
Length: 84mm
Width: 38mm
Height: 82mm
Move Range: 50mm
Mount:1/4 thread
Package Included:
Lifter Focusing Rail Slider x1
S R KINNERSLY
Reviewed in the United Kingdom on April 3, 2024
A good product in principle but the top plate wobbles. Easily fixed by a couple of blobs of araldite (or similar). However, a product described as and intended to be a support for a camera should be rigid not wobbly. The manufacturer really must fix this. In addition, it would be useful if the base plate were compatible with Arca-Swiss mounts as well as 1/4" screw.
karmann Ghia
Reviewed in the United States on October 22, 2023
I bought this for macro photography to mount on a focus rail. There was some play in it that caused the camera to move slightly when focusing. I dis-assembled it and used Loctite Red on the screws and JB Weld on the pins. It's rock-solid now and very acceptable for my use.
Disapointed customer.
Reviewed in Australia on January 14, 2022
Basic tool but is fine once adjusted and Screwed up tight
Alan L.
Reviewed in the United States on September 4, 2019
Very helpful for vertical adjustment of camera (or subject) in a close-up/macro setup. Very sturdy, nicely made. One full turn of the large adjusting nut = 1.4mm, so it's very easy to make adjustments down to 0.1mm, even less. Mounting a focusing slide on top would provide X and Z positioning; mounting an X-Y focusing slide would provide positioning along all three axis.
Recommended Products
