Your cart is empty.
Your cart is empty.
Specifications:
New Hydraulic Log Splitter Pump 13 GPM
Shaft: ½"
Inlet port: 150mm
Outlet port: 230mm
Minimum 8 HP or larger gas engine.
For use with open center hydraulic systems only
Maximum pressure: 3000 PSI
Bolt circle: 2.83in.
4 holes spaced 2" on center
Mounting hole diameter: 344in
Woodruff key: 1/8in
Rotation is clockwise
This 2 stage pump can give you much faster cycle times and higher possible pressures with a small engine. Excellent for use on log splitters. 85% efficient.
The HI/LO section of the pump is all aluminum and the end plates are cast steel. Applications for the HI/LO pump are log splitters, presses etc where rapid movement of the cylinder at low pressure is required prior to automatically switching to the high pressure mode to meet load requirements.
Packing Include:
1 PC 13 GPM Hydraulic Log Splitter Pump
nick
Reviewed in the United States on March 18, 2023
I liked the price.It was an exact fit for my 2022 norteac mini trencher.Same specs as factory.Only complaint if i had any,the suction hose barb is very fine thread and not installed,while installing it makes very fine aluminium shavings as you screw fitting in.so after install of fitting.....fish out these shaving,or youll ruin your new pump.
C Tanner
Reviewed in the United States on December 6, 2023
makes the log splitter faster than before.
Recommended Products
$299.99
$ 99 .00 $99.00