Your cart is empty.
Your cart is empty.Product Description
How to replace 250w blender base gear&shock pad:
Step 1: prepare tools
prepare a dish tower/rag/paper tower, basic flat pliers, and flat-head screwdriver(flat & narrow)
Step 2:
- hold the blades using the towel, take the gear on the back end,
- take the pliers to grip down on the gear using even solid pressure,
- turn the gear clockwise, it will loosen up, and see the little screws.
Step 3:
Grab the towel to hold the blades again, screw the good gear in going counterclockwise, take the pliers to make the gear clamp down tightly
Step 4:
Take out of the base and plastic part using the flat-head screwdriver through the little notch on the bottom
Step 5:
Put the screwdriver into the notch, grab the pliers slide the base in, take the base clockwise out and you will see the thread right. Notice: When you move the screwdriver, the gear will move meanwhile.
Step 6: Change the good base
grab the pliers on one side, tighten the base counterclockwise using the pliers to bite down.
Step 7:
when the blade gear & rubber gear is installed well,the blender will be in good condition.
Step 8:
install the shock pad according the picture shown.
250W Base Gear & Blade Gear & Bushing Shock Pad
22% ( dollar 3.48) less than buying separately
Abdul Basit
Reviewed in the United States on March 5, 2025
Good
Shade
Reviewed in the United States on February 25, 2025
These shock pads fit my Magic Bullet just fine. Saved me from having to buy a whole new unit.
Karl Stephen
Reviewed in the United States on February 25, 2025
Perfect replacement Bushings for the Magic Bullet blender. Replaced the Bushings and no more uneven rotation or grinding noise!
Customer
Reviewed in the United States on September 2, 2024
The product came as described in the advertisement. It fit perfectly in the slots.
Andy
Reviewed in the United States on August 9, 2024
Easy installation and works as it should.
David M.
Reviewed in the United States on March 7, 2024
The original on the left (yellowed), this product on the right. As you can see, there is no portion on the bottom of this bumper to hold it in place very well. I used a dab of silicon to hold it better. The top part is also smaller than the original. It does serve its purpose, so better than throwing the blender away.
sid
Reviewed in the United States on March 29, 2024
Your old pads may be worn out. New pads work nice. You should get the "bundle" where these pads come with the gear parts so you'll have everything at once and it's cheaper this way.
Max Bowerman
Reviewed in the United States on December 27, 2024
Pushed them in and it worked.
Recommended Products