Your cart is empty.
Your cart is empty.Thomas Hall
Reviewed in the United States on July 1, 2024
Fits Razor MX 650 well. Have continued issues with one of the snap rings piping out on the break lever.
Kyle
Reviewed in the United States on June 19, 2024
I purchased these brakes to install on my son's Razor MX500. Super simple install and great quality. These brakes are good when kitting your Razor. They provide better stopping power.
twistedmetal20002
Reviewed in the United States on September 21, 2023
These brakes (not rotors) are direct bolt on for razor mx500. Stopping power is way better than stock razor brakes. These are the cheapest hydraulic brakes I could find recommended. If you have stock razor wheels and hubs, the stock rotors are too think. You need to replace the stock rotors and the ones in this kit don't fit. Search amazon for 160mm 48mm rotors. Many are around $10 each. Get 2 rotors plus this kit for the razor. Should be the same on the mx650.
Tom
Reviewed in the United States on August 9, 2023
Plenty of stopping power and fewer corrosion issues
BRW
Reviewed in the United States on January 19, 2023
So you are not buying top grade Maguras here! But for the price seem like a no brainier to replace cable pull brakes on a budget bike. Nice feel, good stopping power. I can't speak for durability but for the price use them until they fail and feel fine!
Angelica Templeton
Reviewed in the United States on September 28, 2022
The kit included everything needed to install on schwinn axum. Only took 10 minutes to install. Time will tell of the kit holds up. It definitely works much better than the original mechanical disc brakes.
Louie
Reviewed in the United States on December 5, 2022
I was looking for a reasonable hydraulic brakes for my rebuild full suspension bike and found this on 20% off. This thing performs way better and the stopping power is so good and no noise. It has modulation and full stop if needed too proper installation and proper rotors makes the difference, align the brakes and make sure your rotor is clean before and after installation use car brake cleaner to remove grease and some oil from your fingers.Still going strong if you want improved brakes adjust the handle press or change to metal or semi metal brake pads. It is all about the brakepads the calipers are there for function and reliability and i find this reliable just be extra attention if there is piston stuck up on both sides then it is time to service it
Dr_DLH
Reviewed in the United States on November 19, 2022
The only thing I didn’t like is that the handles needed to be swapped from left to right. As the left brake should be connected to rear on the pit bike I installed them on. Unless I was supposed to buy a different pair but I couldn’t locate them. Otherwise they work GREAT!!
Recommended Products