Your cart is empty.
Your cart is empty. Compatible with Toyota 4Runner 1984-2002, Camry 1983-1986, Celica 1978-1981, Corolla 1988-1992, Corona 1974-1982.
Compatible with Toyota Cressida 1978-1984, Land Cruiser 1981-1993, MR2 1985-1987, Paseo 1992-1999, Pickup 1984-1995.
Compatible with Toyota RAV4 1996-2004, Starlet 1981-1983, T100 1993-1998, Tacoma 1995-2001, Tercel 1980-1999, Van 1984-1989.
David K.
Reviewed in the United States on July 30, 2024
These knobs fit perfect on my Daihatsu Hijet mini truck heater controls. They actually look better and are better quality than the originals.
Customer
Reviewed in the United States on July 16, 2024
OEM look and great fit for the heater controls in my Toyota pickup. Recommend them to replace any missing ones. Only needed a couple so it is also nice to have spares since it was a four pack.
jeremy
Reviewed in the United States on November 2, 2024
Fits perfect, awesome looking.
anonymous
Reviewed in the United States on January 19, 2024
The description indicated these would fit early 1st gen Tacoma’s. I purchased to replace some on a 1999 Tacoma and they were not the correct parts and would not fit.I did not use them, but the quality seemed fine.
Toby Harrison
Reviewed in the United States on April 12, 2024
Installed on 3rd Gen 4runner. They went on the heater controls but had to be forced on. Come off easily. Better than nothing.
M Lortz
Reviewed in the United States on October 19, 2023
Like a lot of other reviewers have stated, these control knobs stuck out too far on my vehicle, a 2000 Toyota Tacoma.However, I was able to modify them to get them to sit nice and tight up against the control panel like the original parts.For the 2000 Toyota Tacoma, I measured the attachment points that stick out from the panel. The measurements were 6mm wide by 1.75mm thick by 10mm deep. It is best to use calipers.Next get a piece of scrap metal and file it down to matching dimensions. I was fortunate because I had a small file that fit perfectly.Once you have your scrap metal, lock it in a vice and heat it up with a torch. You could most likely put the metal into a soldering iron or even use a lighter.Heat up the metal and then push the plastic knob to the mounting depth you desire.After I did the modification the knobs still seem to hold on just fine and don't stick out like a sore thumb.
Brett Woodard
Reviewed in the United States on August 29, 2022
I wish they slipped on further, but they haven't fallen off yet.
Ronald G.
Reviewed in the United States on December 22, 2022
These didn’t fit the tracker, but heating a screw driver with a propane torch enlarged them to fit with a little JB weld !
Recommended Products
