Your cart is empty.
Your cart is empty.Product Description
519-CCB2845L
About NICHE
NICHE specializes in the highest quality Powersports replacement parts. Our parts meet or exceed the quality of the original parts that come with your machine. Some of the NICHE product categories include cylinders, brake pads, axles, off-road mirrors, and drive chains. Let NICHE components fix your machine today!
NICHE Clutch Cable 519-CCB2845L
Cable Type: Clutch Cable
- Includes: Clutch Cable
- Compatible with the following brands: Honda
- Compatible with the following models: CX500,CX500C,CX500D,Silver Wing 500 GL500
- Replaces for the following OEM MPN's: 02-0107,22870-415-000, 22870-ME2-000
Cable Comparison
Clutch Cable
What is it?
- A clutch cable allows the vehicle to change gear
Why Replace?
- They break, the constant stress of the cable sliding in and out causes a break at one of the end.
- The cable casing gets damaged due to being close to moving parts, damaged housing causes the cable to bend and corrode.
When to replace?
- A common sign that your clutch cable is damaged and needs replacing is if the clutch lever is stiff or your gear shifts aren’t smooth
Throttle Cable
What is it?
- The engine of your bike needs air and fuel to run. When you turn the throttle, it connects to the pull cable and pulls open the butterfly valve. This allows air to enter the intake manifold
Choke Cable
What is it?
- A choke cable is designed to restrict the flow of air in the carburettor of an engine
Choke Facts
- There is no harm using the choke to start an engine. When it’s cold, it can be a necessity to get started
- Using it a choke will only lead to increase fuel usage, but no damage to the vehicle.
Pull Throttle Cable
What is it?
- This is the cable that pulls open the valve when you turn the throttle. It allows air to get into your engine
When to replace?
- You should replace your throttle cables after three years or 10,000 miles
- If a cable breaks, frays, or you change your handlebar you will need a different cable as well
Push Pull Throttle Cable
What is it?
- A dual cable throttle operation where the pull cable opens the throttle plates, while the push cable, along with a throttle return spring, closes the throttle plates
Installing Tip
- When installing a new cable, make sure to note the routing of the original cable. Also, the dimensions of the new cables must be identical, allowing for the fact that old cables do stretch over time.
Maintenance
- After a race or as often as possible after washing to remove the cables from the bike and flush them through with a blast of air. Also the nipples can also be lubricated, with copper grease
Push Throttle Cable
What is it?
- The push cable is a safety addition, there is a spring that will close the valve whenever the throttle isn’t activated but if the spring fails the push cable safely closes the valve.
When to replace?
- You should replace your throttle cables after three years or 10,000 miles
- If a cable breaks, frays, or you change your handlebar you will need a different cable as well
TheProgrammer
Reviewed in the United States on September 7, 2024
Works great on my 1982 Honda GL500i
Texas Coyote
Reviewed in the United States on September 16, 2024
1979 CX500 Deluxe. Fit perfectly. Exact copy of OEM part.
Patrick Spang
Reviewed in the United States on March 29, 2023
Good quality part, but the length of the cable was a little too long for a CX500
Dnewlin
Reviewed in the United States on October 30, 2023
Worked perfect for my 1979 CX500, feel it could have been a few inches shorter but works as it should
Mirian liset hernandez
Reviewed in the United States on July 11, 2022
Envío rápido, calidad esperada
Recommended Products