Your cart is empty.
Your cart is empty.EXHAUST FLANGE
Young Mcloven
Reviewed in the United States on March 20, 2025
Great product durable easy to use function well and price friendly
Amazie
Reviewed in the United States on May 14, 2023
these are the clamps that came up for tightening down the crossover flange on a JK unlimited . they are too small and the bolts are too small to do the job. I tried all sorts of approaches. Flat out dont fit
Barry B.
Reviewed in the United States on June 11, 2021
Worked very well to replace rusted flange, be sure to use a new gasket to get a tight seal. Also compatible with factory hanger if you clean it up and re weld.
Tim L.
Reviewed in the United States on November 15, 2021
This product worked great on my 2014 Jeep Wrangler JK. I needed to buy two since the original flange bolts rusted away. I also needed longer bolts to reach both flanges. I went with stainless. The split flange bent a little bit since it didn't fit perfectly flat against the original flange, most likely due to the fact that part of the original rusted bolt was still present on the old flange. The need for longer bolts and the fact that it bent under torque are the only reasons that I did not give it 5 stars. Otherwise, it seems to be a great product.
John
Reviewed in the United States on September 11, 2020
I used this as a replacement on the converter side of our outback. It worked great once I got the right side
J. Smith
Reviewed in the United States on December 9, 2019
>Edges of the flange started to bend when tightening, if a lot of torque is needed these may not be the best solution.>Bolt/Nut use a 14mm socket.
Greg Vandy
Reviewed in the United States on October 7, 2019
Solid, well made. Perfect for 2004 cavalier converter exhaust flange repair
Edward
Reviewed in the United States on April 17, 2015
Very well-made and thought-out product. These were used to remedy rusty/thin flanges on my 2000 Frontier and 2001 Xterra's exhaust systems and worked GREAT. By using these I saved the cost of replacing four expensive pipes that had lots of life left but would not seal tightly against the gaskets because the flanges were shot. Note that the exhaust systems I mention above may require two different sizes (this and the 17149 variety) depending on which pipe joints need fixing.
Recommended Products
