Your cart is empty.
Your cart is empty.Great fit just but different bolts
Reviewed in the United States on May 24, 2024
Whitney
Reviewed in the United States on February 19, 2024
This fit perfect. You do have to remove the old threaded nut by removing first the snap rings and then they snap on the new
Krista
Reviewed in the United States on April 9, 2024
Worked great use the hardware from your old cooler and it will bolt up with a little drilling definitely recmond if your not trying to spend money on stock
NM
Reviewed in the United States on January 18, 2023
Fit perfectly. The tabs that hold the screws on top did not match so I used the ones from oem and placed them on here. Bolts at the bottom don’t align but it was already sturdy with top bolts and lines, still added a few discrete zip ties. Works perfect
Berri peterson
Reviewed in the United States on May 19, 2021
We ended up returning this part but not because of fit...... Its an aftermarket piece do the Silk be no perfect fit..... But the seller of this part could not be nicer . it is appreciated emensily .
Frederick F Buckman II
Reviewed in the United States on December 10, 2021
The unit is not OEM. It does not match up 100%. You can use your old screws on top and I used wire ties to lock down the bottom bracket as it does not match at all. The tubing locks right in and no issues. Big money savings over OEM and works great.
Dad of four
Reviewed in the United States on March 7, 2020
This product didn’t fit exactly where the original cooler did. A couple of zip ties will secure it.
Smallville
Reviewed in the United States on October 31, 2019
2007 Yukon Denali XL. It works, and it fit. It does not leak. I'm giving it 3 stars because it was not direct fit. It's close, but I had to bend a few brackets by hand, and it was still tight. The included bolts were SAE I think, and didn't fit the threads on my truck. So, throw them out. Everything considered, the price was good and the product is adequate. It took over an hour to do 15 minutes of work because of the fitment issues, but it works.I spaced out my grille with 2x4 chunks. I marked bolt locations by scribing for the hood latch. I got the hood latch off to the side. That makes it easier to remove and install the cooler bolts at the top. The bottom just has some plastic grommets. Simple clips hold the lines in place. Pop it out. Make sure that you connect and clip your lines to the new cooler before reinstalling the grommets or top bolts. This aftermarket cooler fits so tight, you can't fudge anything around afterward. I basically had to unbolt, and un-grommet the cooler a second time because the lines have no more wiggle room once installed. The lines were in, but slightly in a bind, so I couldn't move them up into clipping position.It's been a month, no leaks. Build quality looks pretty sturdy.
Recommended Products
$35.99
$ 16 .99 $16.99
$108.66
$ 51 .99 $51.99