Shopping Cart

Your cart is empty.

Your cart is empty.

OMNI Racer 1' Worlds LIGHTEST Carbon Fiber Headset Spacer Set: 2,3,5,10,15,20mm

5.0 (3) Write Review
Free shipping on orders over $29.99

$14.95

$ 7 .99 $7.99

In Stock
  • Inside Diameter: 1" (25.6mm), Outside Diameter: 31.65mm
  • Included Heights: 2, 3, 5, 10, 15, 20mm (1 of each size)
  • Weights (grams): Set 24.6g- 2mm: 1.0g, 3mm: .3g, 5mm: 2.1g, 10mm: 4.5g, 15mm: 6.7g, 20mm: 9.0g
  • See below for more details or omniracer.com


Product Description

ABOUT OMNI Racer

OMNI Racer provides some of the World's Lightest cycling components.

OMNI Racer is small young U.S. company with a passion for cycling and dedicated to bringing cyclists innovative, lightweight, and high quality cycling components to riders that seek the lightest and best quality products.

OMNI Racer's products are engineered to optimize the best structural properties of carbon fiber and high strength alloys, creating components at extremely low weights.

NEEDVILLE, TEXAS USA

NOW WARANTEED for LIFE

1" OMNI Racer World's Lightest RACE-Lite Carbon Fiber Headset Spacer Set

1" carbon spacer set

Beatiful Lightweight Design

1" carbon spacer diagram

Fits 1" (25.4mm) fork tubes

1" Carbon spacer set

Full 3K carbon fiber

4 OMC3101-20GLOSSY
PRODUCT FEATURES:
  • Fits 1" forks with threadless, integrated, & internal headsets
  • Material: Full 3K carbon fiber
  • Glossy or Matte finish
  • NO logos for nice clean appearance
  • Inside Diameter: 1" (25.6mm)
  • Outside Diameter: 31.65mm
WEIGHTS: (Grams)

  • 2mm: 1.0
  • 3mm: 1.3
  • 5mm: 2.1
  • 10mm: 4.5
  • 15mm: 6.7
  • 20mm: 9.0

florene comer
Reviewed in the United States on March 8, 2023
These bicycle steerer spacers are nicer than expected and they have that raw carbon look. The6 will look good on your bike if you do need some 1 inch spacers.
Patricia
Reviewed in the United States on March 13, 2022
Just what I was looking for. Fast shipper and easy to communicate with.
Heidi B
Reviewed in the United States on August 19, 2021
These seem ok, however I did notice quite a lot of voids in the layup. It looks like they didn't use enough resin between the layers and perhaps didn't vacuum bag it well enough before curing it. They do seem sturdy enough and should resist the crushing force placed on them when you pre-load your headset bearings. It does look like it is all carbon fiber rather than fiberglass with just the outer layers so that is a plus. The assortment is nice but I'd like to see these a bit less than $10.