Your cart is empty.
Your cart is empty.Pack of 2 Grip Extension for Beretta 3032
Rob
Reviewed in the United States on March 20, 2025
Fits my tomcat 3032 mags like a glove. I recommend it! I used a key to push the little nub in to remove the old ones.
S. Customer
Reviewed in the United States on August 25, 2024
The magazine I got with the pistol (bought used) had a pinky extension on it. I wanted a couple of spares to go with it, ordered flat based mags. Saw these and it said they fit Bersa and Kel-Tec mags, but after I installed them I looked and both said Tomcat on the bottom. Pleasantly surprised.
Randy Greatman
Reviewed in the United States on August 14, 2024
Great product fits perfectly and what a difference when gripping! I highly recommend this extension you will not be disappointed.
MILES CLARK DAV US Marines
Reviewed in the United States on August 12, 2024
These just slid on nice and snug on the bottom of my new Bobcat.22 mags works perfect!
Monty's dad
Reviewed in the United States on July 28, 2024
Bought two for my Keltec P3AT but only received one. They sent 2 more right away. The items fit perfectly. As others have noted, with the P3AT you need to use the OEM flat tab (the part that rests against the spring inside the magazine) instead of the ones in the kit because the OEM tab has two nubs on it that keep the spring aligned, and the ones in the kit do not. Excellent product and service.
Geoff Arnold
Reviewed in the United States on October 19, 2024
Easy to install and improve the grip.
Showtime
Reviewed in the United States on September 25, 2023
I wasn’t sure they would fit the .22 version, but they did. The base plates appear to be the same for the .22 and the 380. This base plate gives you a full grip on the pistol, unlike the factory base plate. With the .22, use the factory metal locking insert that comes out with the old base plate. That one has a bend in it to hold the magazine coil spring in place under compression. The spring will twist under the base plate without it. On the 380 you can use either the one that comes with it, or the factory insert because it’s a conventional magazine spring, not a thin coil type. Very easy swap, I just needed to open up one of the base plate holes to allow it to fit the lock hump better. MAKE SURE YOU ARE READY TO HAVE A SPRING LAUNCH OUT OF THE BOTTOM OF THE MAGAZINE WHEN YOU SLIDE THE OLD MAGAZINE PLATE OFF ! As always, make sure you know what you are doing or have a competent gunsmith do the job. 5 stars for the price.
Stuart S.
Reviewed in the United States on August 27, 2020
Easy and quick to install. Pretty good fit but not perfect. Some sharp edges and corners that I fixed with a file. Definitely improves the grip so I can use two fingers. The magazine takes a little more force to fully seat but I can probably adjust the fit with a file. I haven't had a chance to test the fire the gun with the modified magazines but if they work OK then these ae worth the price.
Recommended Products
$17.77
$ 7 .99 $7.99