Your cart is empty.
Your cart is empty.Product Description
AtmoTac
Reviewed in the United States on August 29, 2024
Very bad quality plastic, it’s wavy and sloppily molded. Also it doesn’t even fit the hawk 250 correctly. Nothing lines up correctly.
Gerry
Reviewed in the United States on August 13, 2024
Parts fit well without any problems. It is flexible plastic, so it takes pumps without breaking. It just had a long shipping time since it comes from China and had to go through customs. There are no instructions so if you didn't have the originals on the bike, it's somewhat of a puzzle to figure them out.
Jenny
Reviewed in the United States on July 15, 2024
Good quality. Very flexible. Good value with the bundle vs buying separate panels. The right panel by the leg was a little tight. Painted up nice with krylon 5x paint. They came white.
MotoADV
Reviewed in the United States on December 9, 2024
Quality was fine, used it in 2021 hawk 250 dlx and everything went on ok but this must cost $10-15 to make. No reason it should be $85
Chris
Reviewed in the United States on December 28, 2024
Got this for my TBR7 250 and fits great!
Robert
Reviewed in the United States on November 3, 2024
Fit just like factory plastics and look amazing
Walter
Reviewed in the United States on October 24, 2024
For my carbed Hawk 250 the plastics technically fit, but in reality you are going to have to go to work. The lower bolt holes on the rear panels will at minimum require bending the standoffs and the front panel's lower support won't work at all. Not great since the front panels don't line up very well with the clip on the gas tank and even if they did the wind is just going to blow them around.I had to dremel out a large portion of a support in the right hand rear panel to avoid grinding on the brake cylinder. The left hand rear panel's lower hole is so far out that I had to use a longer bolt.The front fender comes without the rubber bushings, good luck figuring out how to order those. The originals are hard to remove from the original fender without ruining them, all four of mine got wrecked. Had to just use rubber washers on each side instead.Finally, the plastic is thinner and much more brittle feeling than stock. The black is just a light coating on the outside of the plastic, don't expect them to be somehow more durable because they are colored with carbon or other nonsense like that.This is a very low quality set of plastics to just cover the bike. If it goes over, even in sand, they are all going to instantly crack. If the major wire harness plugs and battery weren't so exposed I would have returned this set and ran without any plastics.
Customer
Reviewed in the United States on April 22, 2024
Fits and looks great on my Hawk 250. Shopping took forever to be fair, but well worth the wait.
Recommended Products