Your cart is empty.
Your cart is empty.Designed to prime the lubricating system of a rebuilt engine prior to its first start to prevent the damage of a dry start. It works by connecting to the oil pump shaft through the distributor hole and inserting in oil pump. For use with 3/8" hand drill.
Jason H Cole
Reviewed in the United States on July 2, 2024
Great price..tool for the job
Erkman
Reviewed in the United States on March 15, 2024
Pre-oiled my old Ford big block. Work exactly as advertised.
Lance Parker
Reviewed in the United States on December 9, 2024
This works great for my Oldsmobile engine. Same as Ford.
Ali
Reviewed in the United States on December 24, 2024
I was going to make one of theses, until I saw the price. The shipping was fast and I cannot make it for less. There is a bit of confusion on how to use theses. I did read elsewhere, many do not realize the Oil Pump drive shaft needs to be installed in the oil pump prior. With the shaft in the pump, the tool is inserted over the shaft and it centers in the block. You then use a drill to prime the pump.
joe
Reviewed in the United States on October 15, 2024
Works great
Tim H.
Reviewed in the United States on July 18, 2022
Cost effective purchase, works great
O. Hansen
Reviewed in the United States on August 2, 2019
I used it on my Ford 460 engine. It worked well. The flat spots on the shaft where the drill chuck clamped insured no slippage.
jack
Reviewed in the United States on October 13, 2017
Couldn’t be easier to use. Had to run my drill in reverse because it is a marine right hand rotation but it got the job done. Make sure you use a powerful drill and you’ll be happy.
Recommended Products
$130.00
$ 57 .99 $57.99