Your cart is empty.
Your cart is empty.Raybestos® Element3® Brake Shoes offer an industry-leading, full category coverage program (including parking brake shoes) for passenger cars, trucks, police, taxi, and fleet-type vehicles that require severe duty performance. Our brake shoes provide stable, balanced braking.
Ben C
Reviewed in the United States on July 3, 2024
Though not easy to get on due to original engineering, they fit as they should.
Builder
Reviewed in the United States on October 27, 2024
Fit perfectly on my F350 Dually--Rear Wheel Drive--with a Dana 80
Cory Davis
Reviewed in the United States on November 27, 2023
These brakes are a pain in the ass to install. I am still in the process of installing them. I had to get new backing plates for them. The hold down pins pulled through the old ones. I will have new parts at the end of the week. If there is a problem with the brakes I will write back and say so. Good luck.I would buy them again it isn't the brakes fault that they are hard to put on.
Duana
Reviewed in the United States on October 22, 2023
Raybestos still makes quality products. Worked nicely on my 2011 ram 2500 4x4. Perfect fit
Kyle
Reviewed in the United States on June 18, 2021
No fitment issues, working perfectly
Moon
Reviewed in the United States on October 24, 2021
The shoes provide what you need to get the job done, except for a parts kit, I highly suggest you get e-brake parts kit when changing these. Also, since the design is poor from Ford on this e-brake design, they are more than difficult to install, but don't blame the shoes for difficulty.
cyclone_dr
Reviewed in the United States on April 24, 2021
I needed to replace the parking brake shoes on my 2006 Ram 3500. These seemed to be priced well and arrived quickly. I also purchased from my local parts store a new spring kit. Once installed, I was unable to get the rotor back on fully, and had to use the angle grinder to carve out a deeper slot on the top and bottom of each of these shoes to get them to create a smaller circle. A bit of a pain to know how much to grind off, and you can't really know if it will work or not until you have all the springs assembled. I ended up using calipers to measure the depth of the OEM parking brake shoe and ground to about that level, if not a few thousandths beyond. At the end of the day, they seem to do the job and I can trust my parking brake again. Was disappointed the fitment was poor and required modification though.
Customer
Reviewed in the United States on September 25, 2020
Quality parts!
Patrice Byrne
Reviewed in Canada on April 10, 2019
Tres bon
Recommended Products
$115.99
$ 53 .99 $53.99