Shopping Cart

Your cart is empty.

Your cart is empty.

RED WOLF 1-2-Both-Off Battery Switch DC 12V-48V 200A, Heavy Duty Marine Battery Power Cut Master Switch Disconnect Isolator Ignition Protected for Automotive RV Marine Battery Kill w/M8 Stud

Free shipping on orders over $29.99

$15.59

$ 6 .99 $6.99

In Stock

1.Style:1-2-both-off Switch


About this item

  • Prevent Battery Drain: 12-48v battery switch is provide a convenient to disconnect the batteries from the electrical system, which refrains battery from draining during storage and isolate power in case of emergencies; Avert accidental discharge, electrical fires, helping you get the most out of your battery
  • Specification: RED WOLF 1-2-Both-Off boat battery cut off switch 12V-48V features On/Off 4 Position; Rating: 200A DC Continuous, 300A DC Intermittent, 1000A DC Cranking; Stud Size: 3 x 5/16" (8mm)
  • 1-2-Both-Off Functionality: Control over which batteries are connected to auto boat's electrical system; Whether you need to isolate a single battery for maintenance or balance the load between multiple batteries for optimal performance, this switch offers unparalleled flexibility
  • Solid & Durable Quality: Power Disconnect w/ABS plastic housing rear cover insulates terminals against any short of circuits; 3 x 5/16"- M8 tinned copper studs and nuts, which is safer and more reliable in electrical conductivity; Flame retardant rating 94VL
  • Widely Application: Battery isolate switch is usually used with the battery box, fuse block which can isolate and protect the electrical system; widely applied to marine, boat, yacht, car, RV, camper, travel trailer, truck, ATV, UTV, etc
  • Easy installation: Straightforward and easy to operate; RED WOLF battery switch is designed for surface, front panel, or rear panel installation, and you can choose any one according to your needs; Clockwise to turn on , counter clockwise to turn off



Product Description

4 Position Battery Switch

1464 x 600
1464 x 600

Control over which batteries are connected to auto boat's electrical system; Whether you need to isolate a single battery for maintenance or balance the load between multiple batteries for optimal performance, this switch offers unparalleled flexibility

Details of Battery Switch

300 x 225
300 x 225
300 x 225
300 x 225
1464 x 600

  • Can stand alone or be locked together with other switch.Its purpose is to eliminate any power draw from the battery when vehicle or boat is not in use, disconnects the battery safely.
  • Avert accidental discharge, electrical fires, helping you get the most out of your battery
1-2 Both 4 Position

Removable

  • 12V-48V features On/Off 4 Position; Rating: 200A DC Continuous, 300A DC Intermittent, 1000A DC Cranking
  • Stud Size: 2 x 5/16" (8mm)
  • ABS plastic housing rear cover insulates terminals against any short of circuits
800 x 600

C. P.
Reviewed in the United States on March 12, 2025
Just added a dual battery system to my off road rig and needed a nice way to isolate/shut the system off that I knew would 100% work. This is that solution! Works great! Easily shut off one or both batteries, allowing you to crank from one or the other.
Nick
Reviewed in the United States on February 5, 2025
This works well as a disconnect switch to isolate 12v battery. Installed on my fifthwheel to prevent the CO2 detector from draining the battery when not in use. I can recommend.
Ace Customer
Reviewed in the United States on January 3, 2025
This switch is smaller, lighter, and much less expensive than some other available battery switches. It is difficult to evaluate the claimed current capacity and I did not test whether it will actually handle 200 amps. Presumably, the rating is the current carrying capacity of the switch rather than the current it can handle while switching.My application is switching a 20 amp battery charger between two battery banks rather than switching the battery banks to a load. This does not seem to tax the switch. To connect two battery banks together to power a load, or switch the load between banks, I would chose a heavier switch from well-established company.
Evangogh
Reviewed in the United States on January 14, 2025
This switch is just what I needed for my DIY solar power bank. It is the main disconnect for the whole system. The switch is well made of sturdy plastic with large lugs for the wires. The knob turns smoothly and clicks into position. I cut a round hole for the knob and mounted it from the inside of the box in order to keep a low profile on the outside. It is working well so far and I've already ordered another.
J. Graeff
Reviewed in the United States on January 11, 2025
I installed this on a battery bank set up. To shut off all power from batteries to consumers. It handles the amperage easily, not surprising. Makes it easy to make sure nothing is using power when I don't need to.
Trippy
Reviewed in the United States on January 1, 2025
$13 for a little one to both off battery switch is perfect for my RV when I want to store it well I'm not using it. This mechanical switch allows me to shut it off completely instead of the remote switches that constantly are looking for a signal and draining your battery at the same time. Has a very secure switch so you won't accidentally turn it on or off when you leave it sitting. Great quality and great connection!
Steve B
Reviewed in the United States on December 29, 2024
When I tightened the wire to the terminal it crumbled in my hands. Cheaply made.
Everett13-94
Reviewed in the United States on December 26, 2024
I have this installed on the positive side of my PV (solar) input between the panels and my MPPT controller. The switch is very well built and it's easy to identify on/off - it's a 90-degree turn from on to off / off to on.The front of the switch has a little white sticker with an arrow and a little image of a battery. This fell off almost immediately upon opening, however.Lugs / O-Rings were NOT included (nor expected) but just be aware if you are looking for a switch with these included.
Recommended Products