Shopping Cart

Your cart is empty.

Your cart is empty.

Rizoma Conical 29mm Handlebar, Low Bend, Black (MA006B)

4.4 (1) Write Review
Free shipping on orders over $29.99

$136.00

$ 53 .99 $53.99

In Stock

About this item

  • These Rizoma thick walled aluminum bars are 29mm (1-1/8") at the mounting point and 22mm (7/8") in diameter at the controls.
  • If replacing standard 7/8" Bars, you can use rizoma's AZ402B or AZ403B Risers, listed seperately
  • Please see the measurements of these in the attached picture


These Rizoma thick walled aluminum bars are 29mm (1-1/8") at the mounting point and 22mm (7/8") in diameter at the controls. This design not only make the bars stronger, it helps minimize vibration transmitted through the bars. The Dimensions for each bend are listed in the picture. If you don't see the bend you're looking for listed, feel free to contact us. There are 4 available bends: Low Bend(MA006): Low Bend with the control section angled back slightly more towards the rider. High Bend (MA009): 20mm Higher than the low bar, with a less swept back control section. A Cross-brace is available for this bar, Listed separately. Sport Bend (MA011) Lowest rise, with less pullback for a more weight forward position. Drag Bar (MA015) Very low/Flat and forward, almost no pullback.


auraaura
Reviewed in the United States on August 8, 2024
I've got a 2022 yamaha xsr900. It had a pretty much sit up straight riding position. I was wanting a little lower/more aggressive riding position. These bars did the trick. Look good too. Installation was a PIA but that's not the fault of these bars. I would recommend these handlebars.