Your cart is empty.
Your cart is empty. Color:Blue,Gold
Material:Brass,Plastic
Screw Size:M4
Hole Diameter:5mm/0.2"
Mounting Hole Diameter:4mm/0.16"
Mounting Hole Center Distance:69mm/2.7"
Total Size:83 x 12 x 21mm/3.3" x 0.5" x 0.8"(L*W*H)
Paul Leonard Trower
Reviewed in Australia on September 19, 2024
Exactly what I expected when I ordered the product. They did the job I required perfectly.
The Bull
Reviewed in the United States on February 17, 2024
I used this to ground my Cellular Exterior Antenna. I have a Waveform panel Cellular antenna, which has 4 internal antennas. I was able to ground each lightning surger protector to the RLECs Terminal Bus Bar and then to a ground stake that is in the ground.
Brian Thomas
Reviewed in the United States on November 10, 2024
We try to buy from the Ma and Pa places on here.Being disabled . We need to be price conscious.At "The Mother In Laws Place"It is an off-grid cabin, we run DC on a lot of things .We see no need to use the inverter 24/7.just so you can turn on a light when you come home .We use LED bulbs in ceiling mount fixtures that are marked 12-volt DC only.These are controlled by controller with a FOB remote.The controller is board mounted on our PV control center .We use a few of the controllers for different rooms to control each ceiling light .We also run the kitchen stove exhaust fan with DC .The fresh air intake system for combustion is DC .These are fused in our DC only fuse center .This fuse center is controlled by a service disconnect at the DC master box .We also run two AC fuse boxes on our PV board .One protects various AC 110 volt circuits in the cabin , garage and sauna .The other protects 220 volt circuits from the aux gen set and to the split ac/heat pump and the aux battery charger for when the PV and hopefully soon to be wind generated power are not enough to keep up.We run 8 - 6volt Rolls batteries tied by Buss bars .They are temperature and voltage monitored on the PV board and by the inverter unit.The power is inverted by a Renogy 3000 .It also has a multi stage charger built it with flow through capability .These are almost all protected by Breakers purchased here .We have a remote shallow well system that we use a soft start unit on .It lessens the instant draw on the system .It is all about power management.This is a semi detailed , general description of some of the off grid power systems we use .
Sergio
Reviewed in the United States on October 23, 2024
Good
Kenneth Duke Masters
Reviewed in the United States on June 12, 2023
The screw heads crumble on a #12 solid grounding conductor, not over torqued. Will replace with better.
Soarwitheagles
Reviewed in the United States on March 13, 2023
I recently passed my technician, general and extra amateur radio exams. Then I purchased some nice radio gear. I read that nearly all radio gear must be grounded. After looking at all sorts of options, this RLECS 2pcs Terminal Bus Bar Terminal Block Brass Wire Screw Terminal Grounding Strip Bus Bar Block popped up during a Google search.I purchased it, installed it, mounted the ground wires and am super happy with how easy it was to install and use!A+++++++++++
David Longoria
Reviewed in the United States on April 20, 2023
Better focal point for grounding multiple negative wires
G. Anderson
Reviewed in the United States on February 16, 2022
One end was attached at an angle. Since no one can see it I used it anyway.
Customer
Reviewed in the United States on November 15, 2022
Works great as a grounding strip. Not for large wire…good for up to 10 awg.
Recommended Products
$13.99
$ 7 .99 $7.99