Your cart is empty.
Your cart is empty.
Power Ratings:
RMS Power Output:Stereo 8 Ohm: 2 x 700W. Stereo 4 Ohm: 2 x 1000W. Bridged 8 Ohm: 1 x 2000W. Peak Power Output: Stereo 4 Ohm: 2 x 3500W Max. Bridged 8 Ohm: 1 x 7000W Max
Terminals:
Input Terminals: Combo jack (XLR and ¼”) A & B inputs. Output Terminals Banana binding post speaker output. Speakon output. XLR output to connect another amplifier or powered sub
Features:
Rockville RPA14 7000 Watt Peak 2 Channel Professional/DJ Rack Mount Amplifier. LCD displays volume in dB per channel and operating temperature. 2U rack space. Built in limiter protects your speakers from distortion and clipping. Bridged mode allows you to combine both channels power into one channel for use with a subwoofer. Stereo mode is perfect for (2) speakers or (4) speakers in a left and right configuration. Parallel mode gives you dual mono output signal which is perfect for monitor use when you want all sounds coming out of each speaker instead of a left/right configuration. Built in crossover switch (bypass, 80 Hz, 160 Hz) allows amp to be used with full range PA speakers, or Subwoofer(s). Channel A & B Clipping Led Indicators. Channel A & B Separate Level Controls. Power, signal, clipping, and protection LED indicators on front of amp. Heavy duty rack mount ears. Built-in variable high velocity quiet cooling fans. Maximum headroom for 4-ohm and 8-ohm Speakers. Level controls for precise setting and matching of sensitivity. Computer controlled IC protection circuitry against speaker short circuit, thermal over load, DC over load. User serviceable fuse (20A, 250V). Frequency Response (bandwidth @ 2Vrms out, @ -3.0dB) 10 Hz – 30 Khz. THD + Noise @ 1Khz full power: 400:1. Effective damping factor (100Hz, 10w, 4 Ohms) 1.08. Output impedance at speaker terminals: 0.09214 Ohms. Frequency Response vs THD+N (worst case, across normal bandwidth 1W) 0.6%. Signal to Noise Ratio: > 100dB. IMD 60Hz & 1kHz, 4:1:
eagle4315
Reviewed in the United States on September 27, 2024
So far so good. I haven't used it for longer than 2 hours at a time yet but I am impressed. I have two 18 inch subwoofers I am powering with this and it had plenty of power. I had items vibrating off my shelves and walls in my house.
Jcotton
Reviewed in the United States on August 1, 2024
Bought this product to run our church speakers it is running great.
Miguel Sanchez
Reviewed in the United States on November 6, 2024
The media could not be loaded.
andinconclusion
Reviewed in the United States on July 26, 2023
‘Bought this to drive 2x 500 watt passive monitors. My 200 watt Ampeg gives the monitors more volume. Quality of sound from the Rockville is reasonable. However, forget about using Speakon connections. I tried 4 different Speakon connectors with zero ability to push in and twist. Yet those same Speakon connectors insert twist and work on my other amps. Bottom line for me: Nice and well built heavy unit, power is over rated comparatively estimated by around 50%, and the only speaker connection on my unit is via spade no Speakon connectors. So unfortunately, it’s a meh!
Los
Reviewed in the United States on June 15, 2023
Bought this amp to replace an older amp. I connected my Mixer to the EQ then to my New Rockvill Amp RPA 14. Quued up asong and cranked up th volumn. Crisp clear sound. Excellent product! Ended up returning one channel wasn’t working. I did however buy another of the same. Fingers crossed both channels will work.
Vic Tapia
Reviewed in the United States on February 4, 2022
Find another amp company
Bill Porter
Reviewed in the United States on May 26, 2021
Update 10/14/21: I have had these amps for a while now and they are still going strong. Bought 2 more in addition to the original 2. I would refer anyone, who asks, to ise them.Original review: Overall, I am very pleased with the Rockville RPA14.This amp pushes a pair of Yamaha SW218v's with ease. I don't think the rated peak wattage is accurate on a per channel basis at 4 ohm as described though, I believe it to be lower. However, I anticipated it to be more powerful than my subs could handle and would have had to adjust gain down on my driverack anyhow and sized the amp to speaker in that fashion.Now that I got that info out of the way, let me hit some solid points.I ran this amp full bore this evening. Both channels max gain. Dropped gain down completely for the subs in my driverack. Unity on mixer channel for my mp3 player, LR on Unity. Raised gain on subs in driverack until it barely started clipping a little since in a while, then backed it down 3 dB.Let me just say, it's the first time I heard the true voice of my subs. They were singing their low tones like they should be, and doing it wonderfully. I was pleasantly surprised how well this amp sounds. Very pleased with how my subs are hitting with this amp. Now in a few weeks, I will be adding 2 more sub cabinets to my front of house, I already have a second RPA14 that is supposed to deliver tomorrow. That one is for the new pair of SW218v's I am ordering next week. I truly can not wait to hear this setup. Reliability is the only area that I will need to keep an eye on as that comes with time of use. If it holds up well, then it's a win win all the way around.
Patrick
Reviewed in the United States on April 18, 2021
This amp is the greatest so much power it is really the heart of my stereo SO LOUD 🔊📢🔊📢🔊📢🔊📢🔊 you need a remote for the stereo because you can't get that close to turn it up
Recommended Products
$279.99
$ 99 .00 $99.00
$39.99
$ 19 .99 $19.99
$1,079.00
$ 99 .00 $99.00