Your cart is empty.
Your cart is empty.Customer
Reviewed in the United States on September 24, 2024
This is meant for a Tesla as the pads have the points to fit the Tesla. I used it on a truck that had openings in the frame. The holes were large enough that the points on this jacks’ pads went in and it didn’t affect it lifting the trucks side I needed to. The wrench that comes with the jack makes it easy to raise and lower the jack. I might get one of those adapters so it can be on a drill. Since I was testing it on a truck and not a Tesla, I wanted to go slow anyway to make sure it worked. It did great.I recommend this jack as it can be used on other vehicles, not just a Tesla.
Kevin
Reviewed in the United States on August 2, 2024
I got a bad flat in my Tesla 3 and I could not jack it up. Tesla does not include a jack or a spare tire and you should use a puck to avoid battery damage. This jack is sturdy. It looks very similar to a 3 ton scissors jack I got. But it has a perfectly shaped puck holder. It is about as low as you can get with a scissors jack. The only way you could go lower is a racing floor jack which would be huge, heavy and expensive. Floor jacks are probably too heavy to carry around in your car.You might carry a small block of metal or hardwood to slip into the puck holder in case your car is too low and you need to get it higher off the ground before using the puck in the correct position and maybe a brick or small jack stand while you relocate the jack to the correct position.Great little jack seems plenty durable and the jack arm/tool appears to have a screw to attach it so it doesn't slip off while jacking. This is a nice add. And the two pucks are a nice addition to jack two wheels at a time if needed of if you lose one as they sometimes stuck in the whole and people forget to take them out.Great unit. I recommend this for Tesla. The puck holder seems to be removable with a C-clamp holding it on. So it could be used with other cars if you remove that puck holder or make a piece that fits in the puck holder but is flat and about a 1/4 inch high.
Steve W
Reviewed in the United States on November 9, 2024
Seems to be fine. I have yet to use it to say anything about it
Recommended Products