Your cart is empty.
Your cart is empty.This kit has four sizes of screw terminal blocks and 40 pieces total. There are five two-pole and five three-pole connectors for each size. The kit consists of screw terminal blocks with the following pitch/pin spacing: 2.54mm, 3.8mm, 5.0mm, and 7.5mm. This variety pack has screw terminal blocks accommodating many different wire sizes, pitches, currents, and voltages. See the photo with the datasheets for current and voltage ratings and other specifications.
JWSmythe
Reviewed in the United States on January 3, 2024
The pins on the small one are a little too short to fit in my breadboard securely. It pops out occasionally when handled. It's a temporary application, so I'll get some better ones for the next project. The screw-down part does hold the wires securely. It'd probably be perfect if you're soldering them into a board. Just not to hot for breadboards, despite the claim in the description.
Philip Dugas
Reviewed in the United States on May 25, 2021
Wrong sizes . don't fit
TAJ
Reviewed in the United States on January 12, 2021
this product was used to repair and a install a controller on a water well drilling rig.
Mr Del
Reviewed in the United States on November 13, 2019
Good selection and quality
Recommended Products
