Your cart is empty.
Your cart is empty.The drop-in V.1 hidden horn is constructed of powder coated steel and injection molded nylon. At 106 decibels and a frequency (Hz) of 440±20A this horn meets ABYC standard A-23. Kit includes horn plus one each chrome and white decorative billet snap-in grills. For use on vessels under 39'. 12VDC. Required hole size, 1-7/8" x 3-3/8".
Allen Look
Reviewed in the United States on September 15, 2021
Our old boat horn died. I tried spraying WD-40 into it, as I read they sometimes just get crudded up and need to be cleaned out, but that didn't work. Once I verified I had voltage, I dropped in this direct replacement and it worked great. A little wimpy for our big boat, but I'm back in compliance and that's all that counts.
Customer
Reviewed in the United States on July 28, 2021
I replaced both horns on my boat.These fit the oem holes and the hardest part of installing them was removing the old gasket material. Easy straight forward wiring, says in directions that horns are not polarity sensitive
Michael Dodge
Reviewed in the United States on June 17, 2021
It was an exact match. While not overly loud it does fit in the hole and place of the hold horn without cutting a new opening. It comes with 2 covers, one white plastic and one plastic chrome.
Customer
Reviewed in the United States on May 13, 2021
Bought this to replace my non working horn. Works like it should. Easy to install.
James L.
Reviewed in the United States on November 18, 2021
Fit just like the Original one on my boat
GOLD789
Reviewed in the United States on October 20, 2021
boat horn
James R Clancy
Reviewed in Canada on July 28, 2020
This item fit perfectly into the existing hole, was dead simple to hook up (the horn is not polarized so it doesn't matter which is + or -). Worked like a dream
T D
Reviewed in the United States on October 27, 2020
This horn was an exact replacement for the older original horn. I just popped the old cover off on the outside of the boat then unscrewed the two screws removed the old horn and unhooked the two wires. Then I just did the reverse by attaching the two wires to the new horn put it in the original hole and put the two screws in and popped on the plastic cover. I put the chrome cover on my boat and it looks good.
Recommended Products
