Your cart is empty.
Your cart is empty.Product Description
Shower Door Threshold Bath Water Dam Barrier
Are you still annoyed by the overflow of water from the sink?
Are you still worrying about water leakage in the shower or bathroom because the threshold is not high enough?
Are you still worrying that the gap between the stove and the wall is difficult to clean?
You can try to install this water guard at the bottom of the window sill, the gap between the grass sill, the joint and the periphery of the washstand and the wall. Not only does it not leak anymore, it also beautified the decoration!
Installation Step
Clean and Dry the Surface
Clean the surface to ensure that it is free of dust and dirt. Measure the length you wish to glue and make a mark.
Peel and Stick
Cut the strip to your own size, then peel off the bottom layer and mount it on the surface with pressure.
Glue the Edge Seam
Caulk the edges with sealant to seal and make it stronger, especially if you are installing it over cement tiles. (But please know that our package does not include sealant.)
Finish!
Allow the tape to dry and avoid water ingress within 24 hours.
This shower threshold water barrier is widely applied for shower floors, shower trays, kitchen sinks, under bathroom doors, toilets, effictive water dam to prevent overflow of water.
Please Note:
- The glue on the underside of the water barrier has not yet completely melted due to the weather conditions. Heat the underside of the shower barrier with a hair dryer before use so that the adhesive melts completely and adheres better.
- Seal the edges with sealant after installation so that it will not come off later and will last longer(The sealant is Not Included in the package).
- The joint height of the shower enclosure is only 1.2cm/0.47in, it can't block the water flow with a height of more than 1.2cm.
- Manual measurement, please allow slight errors on size. The color may exist a slight difference due to different screen displays.
Warm Tips for Installation:
- Leave the roll on the floor for 24 hours to restore its original shape.
- At the corners we recommend cutting to 45 degrees, then spice the two parts at 90 degrees to paste.
K Mokihana
Reviewed in the United States on April 1, 2025
the adhesive is not strong enough and was useless with first use!
rolltideadam
Reviewed in the United States on July 24, 2024
As long as the adhesive on the back of the rubber holds, this will be a 100% fix to the issue I was having with water getting in the bottom of the shower door.
Sergio G.
Reviewed in the United States on February 14, 2024
I got this to use as a water redirecting on the outside of my door, it stock to it very good(i did cleaned the door really good before sticking it) once you clean the door really good take the plastic covering the glue tape and press hard against the door, you must press hard to get it to stick otherwise it wont and it will come of. It stock really wood and it is doing its job.
Richard
Reviewed in the United States on January 7, 2024
cut to length. peel off the adhesive cover. and apply where needed.
H.V.
Reviewed in the United States on April 2, 2024
Adhesive doesn’t stay on, water touch it the whole thing came right off
Recommended Products