Your cart is empty.
Your cart is empty.The Seymour Duncan TS-1 allows you to expand your tonal palette by accessing three unique tones from a humbucker, thanks to the TS-1 mounting ring that holds two small switches. For use with nearly any humbucker and Trembucker pickups with four-conductor cable, Seymour Duncan or otherwise. It is the perfect match for the P-Rails. This "stealth" pickup switching device allows you to access series, parallel and split wirings with a standard humbucker. And it's easy to install. Just solder your pickup leads to a small color-coded circuit board. That's it. Push the two switches towards each other for standard series wiring; away from each other for parallel wiring; and both towards one coil (either one) to shut that coil off. Specifications Inside: 2.780 x 1.470 inches Outside: 3.54 x 1.78 inches Pickup mounting hole spacing: 3.076 inches on center Trim ring mounting hole spacing: 3.20 x 1.513 inches on center Height: 0.200 inches (ring), 0.328 inches (switch casing) Circuit board: 1.353 x 0.402 inches Soundboard Radius: 43.5 ft Note: Will not fit Nickel and Gold covered Trembuckers.
Jonathan
Reviewed in the United States on April 12, 2025
Very flimsy, broke the ribbon wire connecting everything. Bought a new one and eventually it just stopped working. Everything is fragile cheap plastic and doesn't hold up well at all.
Cfv
Reviewed in the United States on March 6, 2017
Ok
Recommended Products
$178.00
$ 71 .99 $71.99