Your cart is empty.
Your cart is empty.The W1857 8" Jointer with Mobile base is a feature packed machine with so much to offer including a thermal protection switch, built-in Mobile base, heavy duty cast iron hand wheels, and Taiwanese build quality. Also, you'll get 25% more cuts per minute with the four knife cutter head, which leaves a smoother finish and requires less sanding than the typical three knife models. Step up to this larger capacity 8" Jointer and be confident that you Made a great decision!
Restoration Concrete LLC
Reviewed in the United States on January 28, 2024
This is an amazing jointer. Only wish I had gotten a slightly longer bed, but it will work for sure. The shipping was a joke, but Amazon was right there to make it right. The on off switch is perfect.
Wood Worker
Reviewed in the United States on July 8, 2022
I purchased this very nice machine for my professional cabinet/wood working business over a year ago. I use it nearly every job. It is very affordable and works well with the high volume of usage I put it through. No need to buy a more expensive tool when you have this machine. The built in mobile base was nice before it found its permanent spot it my shop. The feature for making rabbet cuts is super sweet and I still haven’t had to sharpen or replace the knife yet. It’s a great deal.
Mike Johnson
Reviewed in the United States on June 14, 2022
Without a jointer I would be very limited in the lumber I could use. This has flawlessly for.
Customer
Reviewed in the United States on January 18, 2021
I was able to use my skid steer to unload it from the transport shipper. After that I was on my own to assemble. The packaging was a little flimsy but the jointer appeared to be in perfect condition after unboxing. The instructions call for 3 people to lift to assemble, but using some 4x4 blocks I was able to lift it in increments to the desired height and slide it onto the base using some scrap plywood. The remaining assembly took about 30 minutes. First cut had a little snipe but after adjusting the outfeed it's virtually snipe free. You will need a GOOD dust collector. The chip port is a simple chute and the base to machine point is not airtight, so there's a lot of waste air coming into the top of the chute. My last jointer was a Powermatic and I think I'm liking this one more.
Blake
Reviewed in the United States on March 3, 2020
Best tool in the shop
Coach Larry
Reviewed in the United States on December 16, 2019
Easy assembly with two people. Cutters needed adjusted, and also followed all other alignment instructions. Works great, and is very quiet.
Recommended Products
$109.00
$ 44 .99 $44.99