Your cart is empty.
Your cart is empty.Standard Motor Products S776 Pigtail/Socket
DGC
Reviewed in the United States on September 25, 2024
This fit my 98 dakota perfectly. worked exactly as desired
GPantis
Reviewed in the United States on July 22, 2024
Fits as it should just as the OEM
Will R
Reviewed in the United States on July 18, 2024
Very sturdy construction, easy plug-in installation, and performs as expected/needed. Will probably buy again when I get around to replacing the other sockets of my XJ.
Chad
Reviewed in the United States on November 10, 2024
After trying to track the issue of my marker light not working popped the new plug on and didn’t have a problem since.
ST in Collinsville
Reviewed in the United States on May 11, 2023
This part is a direct replacement for the OEM part on my 2002 Jeep, right down to the numbers in the casting. These fixed my turn signal issue.
Vaughn R. Teegarden
Reviewed in the United States on June 30, 2021
If you watch utube videos about the installation many will take the headlight out to work on the turn signals on a 1997 Dodge Dakota. It is not necessary. just remove the little rubber seal between the grill and lights, take one screw out between the turn signal lenses and pull straight out. Somewhat tight space to work in but it can be done in less than 10 minutes. Part worked perfectly and arrived quickly. All good.
C Homrich Jr.
Reviewed in the United States on March 24, 2020
Product was an exact replacement part for my 1998 Dodge Dakota. Prior to buying these replacement sockets, my front right turn signals wouldn’t work at all. The rear would, but not the front. So at that time I determined it was an aged socket causing the issue. I replaced both sockets on that side since I was going to have it apart anyhow, I figured I may as well just replace both at the same time. Replacement of parts took less than 10 minutes. Everything snapped together firmly as they should, bulbs are held in securely. Turn signals now work as they should.
Aaron
Reviewed in the United States on July 22, 2015
The only reason I four star this item is because, once you twist it into the light housing, it faces down a little instead of to the side like oem. This makes it near impossible to fit the lens back on the truck. I had to keep them loose in the housing. Then once I installed the light assembly I had to reach up from underneath the truck and twist them tight.
Recommended Products
$12.99
$ 5 .99 $5.99