Your cart is empty.
Your cart is empty.David Wright
Reviewed in the United States on February 6, 2022
I bought this for a 2006 Subaru Outback 2.5i and this car does not have the turbo. All you get is the timing belt cover - there are no rubber gaskets and there is no rubber inspection port plug so if you don't have these then you will need them - you may need the rubber gaskets anyway - see below. This timing belt cover fits fine and it works with the existing rear cover and drivers side front timing belt cover sections, however, there is a slight difference between the original timing belt cover and the new one. The difference is on the lower drivers side of the covers. In my case, the original has about a 1/2 inch dip that is about an 1.5 inches wide where the cover attaches. This dip is filled in with a thick section of the original rubber gasket, which brings the dip section level with the sealing edge of the cover. The new cover does not have this dip so you will need the new gaskets if your old cover has the dip. In my case, I cut the old gasket to level it out then used a sharpened small screw drive and a razor blade to carefully cut a trench in the old rubber gasket so it would fit right -this is tedious and time consuming to get it right. If I knew upfront that there was a little bit of a difference between the old and new covers then I would have bought new gaskets rather than spend an additional hour reshaping the old gasket.
sweetpea3766
Reviewed in the United States on September 14, 2021
Had to replace it for my car and the price was good and shipping came right away
John an Customer
Reviewed in the United States on September 4, 2017
After the A/C tensioner cut through my original this worked great to get me safely back on the road.
C. Taylor
Reviewed in the United States on July 13, 2017
Nice factory fit.
Recommended Products
$98.00
$ 44 .99 $44.99
$50.49
$ 25 .99 $25.99