Your cart is empty.
Your cart is empty.Follow Instructions to Seal Your Cut Molding and Protect it from Peeling or Falling off
1. Press tip on flat surface for 15-30 seconds to prime
2. Occasionally re-press tip to moisten
3. Use chisel tip for wide stroke, and use the bullet tipe for fine line
Allow 30-60 minutes of drying time.
Always close cap when not in use.
Mike Swierk
Reviewed in the United States on February 23, 2025
This one was a dud, dried out. Unfortunate.
Mark Webster
Reviewed in the United States on January 13, 2025
I know these sorts of things (even common adhesives will harden on the store shelf) can't sit around on a shelf for very long, but my attempted use was only a short time after receiving the merchandise. The sealant was almost dried up and it was very difficult to attempt applying it to my boat's vinyl letter name on the hull. I ended up having to use my wife's fingernail polish, so I wasn't happy about that. I wanted to like this product because there aren't many possible solutions like it. Perhaps if it wasn't dried up it would have functioned better, but it's not an inexpensive item so to have to throw it in the trash since it didn't work was disappointing.
Michelle LaFountain
Reviewed in the United States on September 14, 2024
It’s a relatively expensive finicky product and does not go far; however, I’ve been unable to find anything else on the market that’s better.
Recommended Products
