Your cart is empty.
Your cart is empty.
Model: For Traxxas trx4m 1/18 high trail f150 light kit
100% new
Material: PLA+ plastic
Color: Black
Installation method
Procedure For installing Front Rear Lamp
Reserve dome light interface, front lights directly remove the black back cover of the original lamp cup, with this set of lights directly mounted on it, the rear lights red lamp beads two, directly pressed into the original lamp cup inside you can.rc crawler roof lights installation steps
Need to match the store's front and rear lights supporting the use of responsible for the inability to light up, installation, please refer to the details of the picture to press the lamp beads to the original inside the light shell, the alignment of the reference to the details of the picture through the original silver frame, the car shell openings car shell details of the picture 12 to open the two 2mm holes, and then dismantle the white terminal to put the line through the past to re-install back to the terminals to connect to the front and rear lamps with the reserved interface can be lit up. Note that when removing the terminals to install back pay attention to the positive and negative poles, do not install the reverse.Raymond d.
Reviewed in the United States on March 22, 2025
Ordered one kit three weeks ago it came in fit my trx4m high trail perfectly. Nice lights. Ok ordered another kit for my other trx4m k10 tried to instal they were obviously to large they are for 10 scale clearly says on order for 1/18 trx4m
Bobalob615
Reviewed in the United States on January 3, 2025
Only downside are the headlights are white and the roll bar is blue.. I used original wiring harness to keep original headlights so that it matched.I used the original head light buckets to mount the new headlights(white) as rock lights.
S Lucy
Reviewed in Canada on July 9, 2024
Will be returning it.
kyle Gregerson
Reviewed in Canada on July 8, 2024
Taillights fit ok, though the wire length was too short. The headlights do not fit the factory location and can only be attached by one out of two screws so the lights are not centered in the lens
Customer
Reviewed in the United States on May 8, 2024
Supposed to be for Traxxas TRX, but it had a FMS esc plug. Luckily I have a Traxxas esc plug so I will change it.
Vicious cycles
Reviewed in the United States on October 22, 2024
Im not sure how others said they didnt fit, or had an FMS plug.....They fit just fine, however the brackets for the front lights are a bit brittle I snapped one of the small ones installing them.The lights were very easy to install, I did have to remove the rear light mounts to get them snapped in properly without risking damaging the wires pushing them in because i cant fit my sausage fingers in that small space.The two wire connector will plug into ANY receiver just fine, it works in my traxxas, Injora, and radiolink, spektrum, and even MJX receivers......I did not use the additional lights for the rollbar since i run my trucks with 3d printed tonneau covers instead.I think these are great value compared to the traxxas overpriced light kit.
Recommended Products
