Shopping Cart

Your cart is empty.

Your cart is empty.

UAYESOK Fiberglass GMRS Base Antenna (462-467 MHz), 7.2dBi High Gain UHF Repeater Signal Booster for BTECH Midland Retevis QYT GMRS Radios HT Scanner Motorola Repeater

Free shipping on orders over $29.99

$93.90

$ 38 .99 $38.99

In Stock

About this item

  • Frequency Range: GMRS 462-467 MHz; VSWR: <1.5; Impedance: 50Ω; Gain: 7.2dBi; Max Power Input-watts: 200 W
  • Connector: SL16-Female/SO239; Length: 1750mm(68 inches); Weight: 1KG; Radiating Element Material: Cu; Radome Material: Fiberglass; Hold Pole Diameter: Ø30~Ø62 mm
  • [Heavy-duty Fiberglass base antenna] Corrosion resistant, waterproof, strong wind resistance; good environmental adaptability
  • [High Gain antenna, Low SWR]Excellent receive and transmit, greatly extend the range of your communication, hit your repeater easily
  • 2 sections Portable design, easy to carry and install



Product Description

gmrs base -2

GMRS Base antenna

  • 7.2dBi High gain benefit, get long distance communication.on GMRS frequencies;
  • High quality fiberglass material, anti-oxidative, corrosion resistant, longer service life

Specification

Frequency Range GMRS 462-467 MHz
VSWR <1.5
Impedance 50Ω
Gain 7.2dBi
Max Power Input-watts 200 W
Polarization Vertical
Lighting Protection Direct Ground
Horizontal Beam Width 360°
Vertical Beam Width 30°/ 19°
Connector SL16-Female/SO239
Length 1750mm
Weight 1KG
Radiating Element Material Cu
Radome Material Fiberglass
Material of Hardware-supplied Aluminum Alloy
Hold Pole Diameter Ø30~Ø62 mm
gmrs-base-1

Every Antenna is individually tested and tuned for GMRS(TX/RX), It has a stable and low SWR in GMRS (462-467 MHz) and UHF


Ryan Brooks
Reviewed in the United States on March 12, 2025
I'm using it as a base antenna for my handheld. 8w ht is able to hit a repeater 98 miles straight line. Tx is strong and clear. Rx is extremely good even on weak signals. Was able to tx/rx on simplex 80 miles.
Edward
Reviewed in the United States on January 1, 2025
Seems like a decent antenna. Cheap u bolts were bent in a press and one was half sheared off and broke while I was installing. Swr didn’t require any tuning for my set up which is nice. All around well worth the money.
Leo R Graywacz
Reviewed in the United States on July 30, 2024
This seems to be the same antenna I got from Retevis, an MA-09. I'm using a 20 watt GMRS radio and I have 84 ft of Messi and Paloni Hyperflex 13 cable. 60 ft to the lightning arrester and then 24 ft to the antenna. Getting a really nice SWR of 1.08.I normally connect with a couple repeaters at 21 miles and 17 miles with no issues. Net control says I am 5x5 into the repeater.The antenna is very lightweight and about 5 feet long. The hardware that comes with it fits nice and so far unlike some other reviewers I didn't have any issues. Both the Retevis and UAYESOK antennas from the looks of it are the same. Both come with the same hardware. I put a reasonable amount of torque on the nuts but not cranking it down hard. I think that is why some of the people complain about the U bolts breaking, but I can't be sure. I can only say I didn't have that problem.The antenna transmits and receives well.
Don H.
Reviewed in the United States on June 26, 2024
Put it on the roof, plugged it in off 50 feet of coax. And it worked just great with a 1 to 1 SWR.
Mack Holbrook
Reviewed in the United States on March 31, 2024
I received this antenna today for my GMRS base station. I didn't use the included hardware based on other reviews that I read, but used a strong steel bracket with two U bolts to attach this antenna to the peak of the eave at the end of my house. I attached LMR-400 low loss UHF cable. I routed my cable down to my radio room, checked my SWR in the middle of the GMRS band and it was reading a perfect 1.00 SWR. When I transmitted my SWR meter was showing a transmission strength of 99.99%. At the far ends of the GMRS spectrum I was still getting 1.05 and 1.06 readings. I was amazed at the performance. I'm surrounded by woods and rolling hills, but I was still hitting a repeater 50 miles away. I used splicing tape and 3M #33 electrical tape to seal my coax connection to the antenna. Buy this antenna, you will not be disappointed for GMRS use. It was lightweight and easy to install in spite of a 20 mile per hour wind blowing this afternoon.
Brooklyn in Texas
Reviewed in the United States on December 4, 2024
this antenna had a low SWR right out of the box no cutting needed
Customer
Reviewed in the United States on April 14, 2024
Replacing the U bolts is a must (one broke while tightening and the other broke while loweringthe mast). As well as the set screw or drill another hole to add a second. After this was completed it was fine. As far as the antenna itself, great SWR 1.1, 30' of LMR 400.
Gregory Ball
Reviewed in the United States on October 25, 2023
I tried several other antennas with no luck. This one does the job beautifully!It gets me into the GMRS flagship linked system at full quieting that's about 35 miles away with lots of mountains and trees in between. Easy installation and great performance!