Your cart is empty.
Your cart is empty. This wall mount and mounting kit for Tempest Weather Station is designed to be flexible, stable and durable. It offers multi-angle adjustment, allowing you to freely adjust the mounting angle as needed to ensure the best data reception. Whether it is roof, eaves or wall mounting, this bracket can easily adapt. Safety is our top priority, and the sturdy base can remain stable even in bad weather. The equipped 45-degree adapter and extension tube connector make the installation method more diverse to meet your various needs.
Material: Base 304 stainless steel, extension rod is 32mm outer diameter, 2.0mm thick plastic tube
Size: Suitable for Tempest Weather Station
Sal DeCarlo
Reviewed in the United States on December 5, 2024
The connection pieces were difficult to secure and do not seem sturdy. It is holding up but I am not comfortable.
Jesse
Reviewed in the United States on December 23, 2024
I was able to pretty easily use this mount for my Tempest weather station to attach to my pavilion. I did notice there is a little play in the hole where the bolts go through to mount to the bracket. Will keep an eye on this but I wish it was 100% rock solid and so far I have not noticed much sway.
Sugarred
Reviewed in the United States on November 11, 2024
Looks good, matches the Tempest like it came with it, and it is easy to adjust, I did install it on the roof, and I used silicone to seal it and my own hot dipped galvanized lag bolt so i don't have to worry about rust. This assuming the pole wont rust, this what happened to the last one I had. Very sturdy, no problem in strong wind
D. Belvedere
Reviewed in the United States on November 1, 2024
The mounting bracket was very easy to put in place. It comes with a rubber mounting plate to help keep the metal bracket from moving and 2 large wood screws to hold it in place. It has been very stable in our moderate breezes (so far, up to 20mph gusts).
D. Lavren
Reviewed in the United States on October 19, 2024
This is an accessories kit that allows you to mount most brands of outdoor weatherstation sensors to either your roof or house side. The kit contains a heavy duty metal base that allows for angular adjustment to match the pitch of your roof. It also comes with a two piece mast that is 32" long. You can assemble the mast straight up or at a 45 degree to allow proper orientation of the sensor. The kit includes mounting stainless steel hardware and a couple of tools as well. You'll need a drill and bit (not included) to make the mounting holes.Would recommend this to anyone.
Recommended Products
