Your cart is empty.
Your cart is empty.Product Description
Feature
The Push-to-connect end can be rotated 360 degrees even after installation, which is convenient to use and has good sealing performance.
Material
Made of plastic and brass, with high strength, good sealing performance and long service life.
Applications
Mainly used for air compression systems, vacuum systems, pneumatic systems.
Note:
1.Make sure that the cutting surface of the pipe is vertical. Please insert the tube into the bottom before use.
2.When inserting the pipe into the joint, it must be inserted into the end, otherwise there may be a leak.
3.After plugging in, try to pull the tube, if you can't pull it out, it means it has been connected.
4.When loosening the tube, first confirm that there is no pressure in the tube, and then evenly press the end cap to the bottom.
Sergey
Reviewed in the United States on August 30, 2024
Threads are undersize if you put them into a proper hole the flange bottoms out before sealing. I ended up trimming the fitting that these go into, so that I could tighten until it seals. Still got 4 proper threads of engagement. Otherwise you'll never get it to seal.
James A. Woodward
Reviewed in the United States on March 15, 2024
Simple installation no water leaks quick connect
Arpix
Reviewed in Canada on December 24, 2024
Work flawlessly, following the exact specifications on Amazon which is one of my main concern generally but here, you get what you buy.
Client d'
Reviewed in Canada on December 16, 2024
excellent très très satisfait a 100/100
David T.
Reviewed in the United States on October 5, 2022
hose will not stay in the fitting
Michael Moore
Reviewed in the United States on October 19, 2022
The push to connect portion works fine...but the threads bottom out before engaging requiring far too much teflon tape to prevent them from leaking...would only use for non-critical applications
Bruce Jason
Reviewed in the United States on June 11, 2021
I received these tonight. Plugged in my 8mm hose and into the connector and into my compressor. I am using a 1/4" universal coupler on my Makita. The compressor fills up and shuts off. All I can hear is air coming out of the new connector. Can someone tell me what I need to do to make these work? Thank you.
Scott Casey
Reviewed in the United States on April 16, 2021
Perfect - a quick fix on an air compressor.
Big Poppa
Reviewed in the United States on September 26, 2019
First off this is anodized aluminum and not brass, secondly the threads are undersized requiring plenty of teflon tape.. typical Chinese garbage quality. Would not buy again
The review
Reviewed in the United States on August 25, 2019
Finally a fitting that actually fits and doesn't leak
Recommended Products