Your cart is empty.
Your cart is empty.ReenoV
Reviewed in the United States on March 3, 2025
These were easy to install and did what they were supposed to do.
anonyme
Reviewed in Canada on February 11, 2025
super
Steven Stromer
Reviewed in the United States on August 30, 2024
Absolutely flawless manufacture. Sharp, well-cut threads.
Jack C
Reviewed in the United States on January 19, 2024
Works as intended. Make sure to purchase or own a 13mm bit. Step up the hole diameter to get to your 13mm.
Steve from ATX
Reviewed in the United States on March 21, 2022
These seem to be a good quality. However, I had purchased a 13mm drill bit for my hardwood chairs (per the product description) and that was too small because the wood started to split when I screwed in the product. I probably should have purchased a larger drill bit, but instead I enlarged the 13mm holes by reaming them out and then lubricating the hole with some Vaseline before screwing in the insert. Also, keep in mind that if you purchase a drill bit, anything larger than 13mm will likely not fit into your drill if you have a 1/2" drill chuck, so make sure you purchase one with a reduced shank. The 13mm non-reduced-shank one just barely fit into my 1/2" drill check.
Mav777
Reviewed in the United States on October 2, 2022
Does what it's supposed to really well.
Allen M
Reviewed in the United States on November 17, 2020
I bought these to repair a cheap ottoman. The factory threaded insert was very thin and broke easily. The uxcell product was much sturdier and longer. It was a little wider than my 1/2" drill bit, so I had to ream out the bore a little bit. The hex top requires a 3/8"/20 mm hex drive/Allen wrench. Would definitely buy this again.
Recommended Products