Your cart is empty.
Your cart is empty.Erik Okerholm
July 26, 2025
Not as big as the brass valve but a good alternative at 1/2 the price. Works the same and easier to use the handle to open/close the valve under my smoker.
bt
June 30, 2025
I replaced a 1.5" PVC ball valve with this stainless steel valve. The plastic valve lasted a couple years and was very difficult to turn on and off. This valve appears to be very well made and has a nice long handle which makes valve operation easy. So much better than the PVC valve. Yes, I would recommend this valve.
MartolFart
June 4, 2025
Had trouble get this on an existing copper MPT fitting.... apparently you should use nickel filled tape or sealant.... since I was freshoutta that stuff, I put some anti seize on the treads with yellow ptfe tape and no leaky.... I found thin threads of copper the ss FPT had shaved off when I redid this, so had to do a thorough cleanup..... I'm hoping for a shut off that works and lasts more than a few years....
Galant
June 1, 2025
No problems with the valves - use them in my lawn irrigation system. Need to use a proper sealing cord.
Waseige
January 21, 2025
Leaked from the cast not the valve itself. There were pin holes from a faulty casting. Plus stainless does not give. I’d changed to brass which was flawless.
michael r.
January 3, 2025
I'm using these in a compressed air pipe system and they stand up to 135psi very well. I would say that they are the Chuck Norris of NPT Female 316 Stainless Steel Full Port Ball Valve with Vinyl Handles.
John
December 19, 2024
Works great.
Kurt Osgood
November 18, 2024
Unit is full port, turns tightly but without catching, and is threaded well, though the threading was a bit short.
Recommended Products