Your cart is empty.
Your cart is empty. Tired of trying to find your washers when it’s time to play? Stop storing them separate from your boards! The Washer Locker is the perfect solution and requires minimal skill to add it to any set of washer boards.
INSTALLATION:
*Washer Boards w/ frames up to 1” thick: Requires only the ability to drill a ½” hole – See instructions below
*Washer Boards w/ frames over 1” thick: May require you to drill/bore a 5/8"+ recess in the exterior of the frame to allow the locker to rest approx ¼ - ½” deep. This is can be done using a large drill, forstner or spade bit.
INSTRUCTIONS:
1. Locate a side wall on your boards with enough clearance to keep your washers inside the frame.
2. Drill a ½” hole in the center of this area.
3. Slide the locker bolt through the wall from the outside to the inside.
4. Place your washers on the locker bolt and secure them using the locking pin provided.
MrLikeke
Reviewed in the United States on May 7, 2018
Great way to store your washers with your board. For a 2x6 baseboard, start with a 5/8” drill bit approximately 1/4” deep then bore through with a1/2” bit. Nice, snug, and solid!
Erick Creegan
Reviewed in the United States on July 30, 2017
Fantastic, simple idea but really makes my boards look nice. It's also very convenient to not have to search for my rings every time I pull my board out.
CPillars
Reviewed in the United States on June 4, 2016
Exactly what I was looking for! Thank You
Recommended Products
$24.99
$ 11 .99 $11.99
$199.97
$ 80 .99 $80.99
$24.99
$ 10 .99 $10.99
$24.49
$ 12 .99 $12.99