Your cart is empty.
Your cart is empty.Product Description
Oldshoes
Reviewed in the United States on August 21, 2024
Nice coil contactor. I swapped out a 1 hp motor on a powermatic model 90 for a two Hp. original coil had a little amperage dial - adjustable coil for amps. I'd never seen that before - I turned her all the way up and for the most part she worked. Occassionally on heavy cuts though she would still blows. The original coil contactor was Westinghouse also. This 30 amp Westinghouse was just sitting around waiting to go into a vintage CJ metal lathe I'm rebuilding with a single phase 5hp. I took coil out of PM90 and popped this in to test - 3 months - no blows. It's too much amperage for a 3 phase 2Hp - but she's on a 20 amp breaker. This is an HVAC amp rating too so it might be lower amp rating for a motor starter - not sure there. Not worried, good she goes, no blows. I'll swap for smaller later.5 Stars for The Westinghouse HVAC Contactor, 3 Pole, 30 Amp, 240V Coil
Jerry
Reviewed in the United States on April 15, 2024
Received in good condition, fast shippingAppears to be a genuine Westinghouse product - Westinghouse well known for making very good products,Kind of a low price for a genuine Westinghouse contactor of this level,At 240vac, coil pulled in very quickly with no chattering,All 3 poles measured under .3Ω on Fluke 77 Series III when engaged,Will have to update later when item is fully installed,Only fault I could find was the identifying sticker was on crooked,
Recommended Products
$19.58
$ 8 .99 $8.99
$26.00
$ 11 .99 $11.99