Your cart is empty.
Your cart is empty.Make full size Stile and Rail joints on your router table. The interlocking design plus the raised panel groove are both cut in one pass. Ball bearing guides control the cutting depth and also allow use on rounded, arched, or special shaped doors. With these two piece sets, simply switch router bits to change from cutting stiles to cutting rails. Ideal for stock from 5/8” to 7/8” thick
CoachCMD
Reviewed in the United States on April 20, 2022
Top quality product with super packaging to protect the bits.Smooth, sharp cutting & result.
Troy
Reviewed in the United States on March 21, 2021
Cut through hard maple like butter. Finish cut was perfectly smooth with zero burning!
Stephen R.
Reviewed in the United States on December 18, 2021
These are superb router bits. I take care to ensure my wood is jointed and squared up properly, and I use good router technique and a powerful Milwaukee router in my table. I am nearly finished a large kitchen remodel with 34 hard maple cabinet doors, plus a number of end panels, and the bits still cut crispy with virtually no tearout.
Kristen Potter
Reviewed in the United States on July 20, 2018
Nice cut. Time will tell how long they last.
Chris Irvin
Reviewed in the United States on January 5, 2017
Whit side are the best router bits on the market.
Customer
Reviewed in the United States on September 18, 2013
Whiteside bits are not cheap by any means. You get what you pay for. I live by the adage that you buy the big cheap set of all the bits and when one breaks, replace that one with quality. When I have a choice I choose Whiteside. They are the most durable, lowest chatter, highest quality bits I have found. Definitely my favorites.
Philip Falso
Reviewed in the United States on October 11, 2013
USA makes better stuff cause we know our reputation is at stake. Bits cut real nice, and I love knowing I bought the best.
J. Reynolds
Reviewed in the United States on August 5, 2012
The 6001 bit set makes excellent clean cut edge surfaces in a variety of hardwoods (& softwood) for great door applications. Make sure you get the right set of cutters for either full 1/4" (domestic) plywood inserts, or, get the the 6001 and 6000X, a separate set of cutters for 5.5mm imported plywood. You are probably going to end up using 5.5mm with very limited North American production of thin hardwood panels staying with 1/4" as the standard. Whiteside does make this set with the 5.5mm cutters standard, but then you'll be rabbeting any full 1/4" panels down to the 5.5mm thickness.Again, Whiteside continues to make the best router bits you have ever or will ever use. Older router bits can not match either carbide or design produced by this Company. The Claremont, NC. based Whiteside is a treat for any professional or accomplished woodworker.
Recommended Products
$129.00
$ 60 .99 $60.99