Your cart is empty.
Your cart is empty.Product Description
Striking face wrenches are designed to be struck by a hammer on the anvil area in order to loosen frozen fasteners or to set and tighten fasteners. Anvils are proportional to opening sizes. Special heat treating provides maximum durability for long life. Straight handle design resists springing while allowing the fastener to turn more easily. Williams' expanded line of offset striking face wrenches, up to 4-5/8", provides the most extensive line on the market. Specifically engineered to hold up under the most rigorous industrial use.
From the Manufacturer
Snap-on Industrial Brand JH Williams 1 1/2-Inch straight pattern box end striking wrench has a striking face wrenches are designed to be struck by a hammer on the anvil area in order to loosen frozen fasteners or to set and tighten fasteners. The anvil is proportional to opening size. The special heat treating provides maximum durability for long life. The straight handle design resists springing while allowing the fastener to turn more easily. This wrench is specifically engineered to hold up under the most industrial use.
Placeholder
Reviewed in the United States on September 7, 2023
for the application of disk brakes on big trucks. a bit of grinding, and finishing needs to be done, and the hammer ends are not flat they are a bit round. nothing that can't be fixed with a bench grinder.
Bradley Ramey
Reviewed in the United States on April 17, 2022
Ram 4500/5500 trucks rear caliper bracket bolt doesn’t give you enough room to use a socket. They’re also torqued to over 400 ft pounds. This wrench works wonders and is way better than trying to use one wrench on the end of another. Worth the money
Derek Y.
Reviewed in the United States on February 28, 2021
Didn’t think the wrench was going to be that small but it does it’s job. Used it for about a week at work and I have no complaints.
Bigislandal
Reviewed in the United States on April 17, 2021
Tried a 40 inch breaker bar w/ three-quarter inch drive to no avail... this wrench... easy Peezy!
Adrian Gillespie
Reviewed in the United States on September 4, 2019
I like that it stayed on the nut without having to keep held in place, it’s very sturdy not like the wimpy one that I replaced it with and this thing will probably out live me, so I have it a five star performance.
Gabriel Ricard
Reviewed in the United States on December 24, 2019
When buying a tool that is intended for bashing repeatedly with a sledge hammer, it's generally a good idea to buy the best tool you can find. Williams tool company makes tools you can depend on, and this series of wrenches is absolutely what you need for bolting that just doesn't yield to normal means of removal. These tools last a lifetime.
Customer
Reviewed in the United States on April 30, 2019
I bought this for a very specific job that I regularly encounter in my profession. Rusted/seized jam nuts.Tried it once so far in a vertical position with a #4 sledge and it did the job fairly well. The 12point bites nicely and didn’t slip. Had to hit it several times though. No fault of the tool. Just the recoil you’d expect because you can’t really hold it while swinging at it. I’m going to get about a 6’ cheater bar to slide over the end for leverage. I’m sure then it’ll be the tool I am looking for.
Kenzie117
Reviewed in the United States on August 14, 2018
The wrench is built heavy duty and the head is strong. I use a two inch piece of pipe over the striking end for leverage instead of striking it with a hammer.
Recommended Products
$108.33
$ 49 .99 $49.99
$236.48
$ 99 .00 $99.00