Your cart is empty.
Your cart is empty.EJOrso
Reviewed in the United States on March 4, 2025
2011 bad boy buggy xto. Fits both front and rear tie rods.
CDM
Reviewed in Canada on June 12, 2023
Easy to install, quick replacement part for our Chinese small ATv, came with all the hardware to install too
RayTX
Reviewed in the United States on March 23, 2023
These are good quality units that are basically universal designed. Check the thread sizes to make sure you are ordering the right ones for your application. This saved me lots of money and worked perfectly!
Angelo Delli Colli
Reviewed in Italy on October 2, 2023
Conforme alla descrizione. Ottimi per il quad delle mie bimbe.Tutto perfetto consigliato
Johann
Reviewed in Germany on October 17, 2023
Alles gut
jean-jacques Carpentier
Reviewed in France on September 30, 2022
Facile à monter
Joe
Reviewed in the United States on July 2, 2022
Worked well for spiderbox yerfdog. Make sure you get 2 packs if using for yerfdog since you need 2 right hand threads. Same price as anywhere else. I kept the other for bushing parts if I ever needed.
Christian Costa
Reviewed in the United States on March 16, 2022
Working good
badpeanut
Reviewed in the United States on October 12, 2020
As other reviewers have stated, one of these tie rod ends is left-hand thread one is right-hand thread. Since I knew this going in, I purchased two pairs since I needed two right-hand thread tie rod ends for my Yerf Dog Spiderbox. These tie rod ends fit well, and appear to be better quality than the original tie rod ends from the kart which I replaced; the yellow zinc plating is also better. These have more thread, which was a benefit in my application.My only complaint is that I couldn't buy two right-hand thread tie rod ends to start with, but I ran into this everywhere I looked.After riding the kart for over a month with these tie rod ends installed, I am happy with the purchase.
blake
Reviewed in the United States on August 15, 2019
This is an inner and an outer for either the left or right. This is not two outer tie rod ends like I was expecting. Unfortunately had to order 2 sets to get two outer tie rod ends. Good quality, just the only ones I can find that are 10-12mm.
nicolas jousseaume
Reviewed in France on December 12, 2019
Bien
FMTIII
Reviewed in the United States on November 26, 2019
Worked great on my g16 golf cart.
CB
Reviewed in the United States on November 13, 2019
The Tie Rod ends fit my application just ok. The reason being that the Tie Rod ends that fit into the steering knuckles and on to the steering column were different lengths for left and right. This makes Castle Nut fit too far down on the shaft. The cotton pin holes were way above when tighten. The nut was down more that 1/2”.Seller should post the length of all major dimensions to aid buyers before purchasing.
Recommended Products