Your cart is empty.
Your cart is empty.(Pack of 10) 1 3/4" 1.75 inch CAPLUGS Flush Mount Black Plastic Body and Sheet Metal Hole Plugs - Head Diameter 2 1/8" - for Panel Thickness 0.03"-0.08". Overall Height 1/4 Inch
Thomas Johnson
July 23, 2025
It was properly sized. Performed well as hoped and expected.
Grandnationalguy
June 21, 2025
They fit the hole perfectly also.
John McMinn
June 14, 2025
fits perfectly
Albert Bentley
June 6, 2025
PRODUCT WORKS AS ADVERTISED. VERY HAPPY WITH IT.
Rohan murray
June 5, 2025
Good material, arrived on time
Chris Thompson
April 26, 2025
if you use a hole saw to drill a 1.75 inch hole it will be a bit too bit for these to fit well.
Eric
March 3, 2025
These fit a 1 3/4” hole perfect. I would say they would work in sheet metal that is 1/8” thick or less. They would work best in materials that are 1/16” thick or less. They are a semi-flexible plastic so I wouldn’t recommend using them in a area where a direct impact could push them in or out. But if you may need to remove the plug sometime it should work great.
Sandy’s home
February 24, 2025
cheap thin piece of crap. plug installs in floor but, if you step on it I'm sure it would fall out after you covered it with carpet
Evan
January 9, 2025
as described.
Rob Whitbourn
December 11, 2024
Well made and fit the holes perfectly
Patrick Qc
December 10, 2024
I was worried, but these 1¾" plugs fits well in my 2001 Mustang bottom floor under rear seats.
william leasak
November 18, 2024
Had to plug off a couple floor holes in an old vehicles floor board , popped in and so far have not popped out
Ray Chang
November 12, 2024
The plugs helped fill an unsightly hole.
Recommended Products
