Shopping Cart

Your cart is empty.

Your cart is empty.

1 3/4' 1.75 inch Flush Mount Black Plastic Body and Sheet Metal Hole Plug Qty 10

Free shipping on orders over $29.99

$6.15

$ 2 .99 $2.99

In Stock

About this item

  • (Pack of 10) 1 3/4" 1.75 inch CAPLUGS Flush Mount Black Plastic Body and Sheet Metal Hole Plugs
  • Head Diameter 2 1/8" - for Panel Thickness 0.03"-0.08". Overall Height 1/4 Inch
  • -Please note: These are for 1 3/4" hole ID. Please check your overlapping requirements and metal thickness before ordering.
  • Please see the specifications picture with measurements for clarity and better understanding of the suitability of the plug you are ordering.


(Pack of 10) 1 3/4" 1.75 inch CAPLUGS Flush Mount Black Plastic Body and Sheet Metal Hole Plugs - Head Diameter 2 1/8" - for Panel Thickness 0.03"-0.08". Overall Height 1/4 Inch


Evan
Reviewed in Canada on February 8, 2025
as described.
Rob Whitbourn
Reviewed in Canada on September 3, 2024
Well made and fit the holes perfectly
Albert Bentley
Reviewed in the United States on August 1, 2024
PRODUCT WORKS AS ADVERTISED. VERY HAPPY WITH IT.
Patrick Qc
Reviewed in Canada on July 31, 2024
I was worried, but these 1¾" plugs fits well in my 2001 Mustang bottom floor under rear seats.
william leasak
Reviewed in Canada on June 3, 2024
Had to plug off a couple floor holes in an old vehicles floor board , popped in and so far have not popped out
John McMinn
Reviewed in the United States on May 2, 2024
fits perfectly
Grandnationalguy
Reviewed in the United States on December 25, 2024
They fit the hole perfectly also.
Thomas Johnson
Reviewed in the United States on August 31, 2023
It was properly sized. Performed well as hoped and expected.
Chris Thompson
Reviewed in the United States on March 25, 2023
if you use a hole saw to drill a 1.75 inch hole it will be a bit too bit for these to fit well.
Ray Chang
Reviewed in Canada on January 20, 2023
The plugs helped fill an unsightly hole.
Rohan murray
Reviewed in the United States on June 17, 2022
Good material, arrived on time
Sandy’s home
Reviewed in the United States on June 16, 2019
cheap thin piece of crap. plug installs in floor but, if you step on it I'm sure it would fall out after you covered it with carpet
Eric
Reviewed in the United States on October 28, 2019
These fit a 1 3/4” hole perfect. I would say they would work in sheet metal that is 1/8” thick or less. They would work best in materials that are 1/16” thick or less. They are a semi-flexible plastic so I wouldn’t recommend using them in a area where a direct impact could push them in or out. But if you may need to remove the plug sometime it should work great.
Recommended Products