Your cart is empty.
Your cart is empty.
Hot Wire Cutter Specification:
Voltage: 110V
Power: 30W
Temperature Range: 50-300°F
Max. Cutting Thickness: 20cm /8"
Installation Steps:
Step 1. Install the pillar and tighten the screw.
Step 2. Install the dimension ruler.
Step 3. Release the wire,take it passing through the hole.
Step 4. Make the wire pass through the board hole, and buckle it in the spring.
Step 5. Turn on the power switch and use the machine.
Package Included:
1 X Table Foam Cutter
1 x Power Cable
1 x Cutting Wire (installed on the rail of the cutting machine)
1 x Wrench
Leo
Reviewed in the United States on May 12, 2024
I needed a foam cutter with a deck that could accommodate 12 inch pieces, this one fits with room to spare. I originally thought that id didnt come with wire, so i bought some separate, but when i went to mount it, i found the included wire on a small spool attached to the arm. Variable heat control helps cut larger foam. Very satisfied.
Leonard
Reviewed in Canada on September 13, 2023
It cuts as expected. A bit too expensive for what it offers. Thank you for your attention.
Toni Saling
Reviewed in the United States on September 11, 2023
My friend loves the size &functionality says it is perfect for making D&D environmental components
Ryan Plaisted
Reviewed in the United States on February 28, 2023
Does not include the wire for the hot wire cutter and In the included instructions is a spring to hold tension which also isn't included.
Mike
Reviewed in the United States on November 15, 2023
It’s a little bulky and needs more detailed measurements and smaller increments on sideboard. Also better support push boards.
Recommended Products
