Your cart is empty.
Your cart is empty.Product Description
rob schleben
Reviewed in the United States on March 29, 2025
Connected to my charger fine.As described
LarryB
Reviewed in the United States on March 22, 2025
I use a lot of NoCo charges in my garage and outbuildings to keep my equipment batteries charged. I prefer to take the time and install them on all of my equipment rather than relying on battery clamps. These secondary market connectors are of good design, have the same wire length as my official ones (18 inches), and appear to use a slightly heavier gauge wire. The connectors have inline fuses to protect the cables in the event of a short. The package comes with a set of fuses from 5A up to 30A, which are too big for the cables’ 16 gauge wire but could be handy for use in the vehicle. In summary, great cables at a lower cost than OEM NoCo Cables. Highly recommended!
Love to hunt
Reviewed in the United States on March 14, 2025
This item shipped and arrived fast. This 2 pack of, XL eyelet charge adapters for NOCO chargers kit is just what I needed. These adapters are very easy to install and give you a pigtail link for charging so you are not fighting to clamp a terminal and or have to remove the battery just to charge it. These work perfect for motorcycles. The charge adapters have a fuse link and come with an assortment of blade fuses so you can chose the amperage needed. The quick connect links fit my NOCO chargers, even my older 3500 series, and have a tight / secure fit. The eyelets are the largest I have seen, are gold plated, and have an insulated cover over the crimped connection. Overall these are well made charge adapters with a good wire gauge size and very convenient to plug and play you're NOCO chargers where batteries are tucked away. I rated these 5 stars.
Matthew F.
Reviewed in the United States on March 14, 2025
This is a cable with a NOCO connector built in with an inline fuse holder and ring terminals. I don't know if other manufacturers use this same connector or not. The ring terminals can be connected to a battery and the connector can be connected to a compatible NOCO battery charger with the corresponding connector on the other end. I use these as a trickle charging port on my vehicles. This makes it easy to connect a charger when the vehicle will be sitting for a while. These connectors come pre-wired with the fuse holder and ring terminals. The fuse holder comes with several fuses for use with whichever is suited to your needs. The connector comes with a rubber cap that securely fits over the ends when not in use. This will prevent unwanted dirt or water from getting into the connector when not in use. It will also keep accidental shorts from happening from something getting into the connector and touching metal on your vehicle. This 2 pack of connectors offers a great value. Always check to be sure the positive and negative side of the connectors correspond to the proper polarity on your accessory.
FairladyZ
Reviewed in the United States on April 7, 2025
These 2 Pack Wire Harness Compatible with NOCO GC008 X-Connect and GC002 X-Connect, M10 (3/8in) and M6 (1/4in) XL Eyelet Terminal Connector, Contains 5 Fuses (10A, 15A, 20A, 25A, 30A) (M10 and M6) work as expected. They plugged into my x- connect with no issues. Quality is decent and I've had no issues yet.
CO Ski Dad
Reviewed in the United States on April 2, 2025
NOTE these are for the NoCo *CHARGERS* and NOT their Jumpstarters. These cables allow "permanently" wiring in a NoCo charger connection and they're almost indistinguishable from the original NoCo cables. I wish the seller had kits which had BOTH sets of terminals the same size - this two-size kit is nice for figuring out what works for your vehicle, but it would still be better to be able to choose sizes/combinations. They fit my Genius 10 without issue and seem pretty close to the originals in terms of construction and overall quality.
Mark Antony
Reviewed in the United States on April 1, 2025
Why Noco didn't just use the normal two prong connectors that virtually every other battery tender comes with is just beyond me, but they did... These work great and will be permanently installed on my lawn tractor with a weak battery.
Brandon
Reviewed in the United States on April 1, 2025
Got these cables to permanently mount to my battery leaving the tail end out of the car for easy plugging and unplugging of my Noco genius battery charger/maintainer. The terminal ends fit my battery just fine and the plug is compatible with my Noco genius charger.
Recommended Products