Shopping Cart

Your cart is empty.

Your cart is empty.

ALL-CARB 2 x Carburetor Carb Repair Kits and Float Replacement for Johnson Evinrude 50 55 60hp

Free shipping on orders over $29.99

$13.26

$ 6 .99 $6.99

In Stock
  • 2 X Carburetor carb kits with float replacement for Johnson Evinrude 50 55 60 HP
  • Replace for Part Number: 392061 396701 398729 Sierra 18-7222 Mallory 9-37107
  • Package Included: 2 x carburetor repair kits
  • Easy to install and reliable to use, professional installation is recommended
  • Please verify this is the right part number before ordering



Product Description

The video showcases the product in use.The video guides you through product setup.The video compares multiple products.The video shows the product being unpacked.
31

Carburetor repair kits with float replacement for Johnson Evinrude 50 55 60 HP outboard motors

32

The kits are made with premium material, accurate machined

33

Easy to install and reliable to use, professional installation is recommended

a44

Please make sure it is the correct part number for you

a6

ABOUT ALL-CARB

Focused on Providing Less-Spend Carburater for Garden Tools.

Established in 2011, ALL-CARB was born from the passion for premium gardening tools and landscaping perfection.


Phil Domeier
Reviewed in the United States on June 3, 2024
1981 Johnson 60hp.Had what I needed to rebuild the carbs on this engine.Neither float valve seat would thread into the carb bodies so I used the old ones.
Customer
Reviewed in the United States on May 29, 2024
The seat that comes with this kit does not screw in and is such junk material I almost cracked it in half with little pressure. The gaskets match for the most part. The o rings are not the same thickness and the piece that comes with it to hold the float bowls in the housing is thin flimsy plastic.. buy a better kit and spend the extra money.
Jacob
Reviewed in the United States on March 25, 2024
Fit my 1976 55 hp evinrude engine perfect
Robyn Mullican
Reviewed in the United States on November 18, 2024
The jets were not threaded correctly. Buy OEM.
David H.
Reviewed in the United States on January 2, 2023
These kits were used for my 1985 50 hp Evinrude.Only used a few of the parts. Flit, needle, seat, bowl gasket, float bowl drain plug gasket, and center feed tube gasket.the parts were correct.Probably will fit a variety of Evinrude/Johnson carburetors.
mark vieira
Reviewed in the United States on June 27, 2022
The needle seats would not thread in completely and began to bind before seating. I cleaned and used the old seats with the new needles but the bottom carb would not seal the fuel flow. When I took it apart the bowl gaskets were coming apart and blocking the float from sealing the needle. I used the old bowl gaskets and was able to finally get them to seal proper. The other gaskets and Welch plugs fit and worked properly so far. I would spend a little more and get a quality rebuild kit
gordon beran
Reviewed in the United States on July 2, 2021
Complete kit for rebuild.
james hunsaker
Reviewed in the United States on October 13, 2021
it all fit very good