Your cart is empty.
Your cart is empty.Package Include: 2*Beer Keg Coupler Fittings with 90° Tail Piece Elbow, 2*Rubber Washers Food Grade Material: The Washer Gaskets are made of Food Grade Silicone. It prevents leakage problems and ensures that you have good experience with Beer Keg Couplers. The Sankey Keg 1/4" Tail Piece Fitting can connect hose securely. High quality and Food grade Keg Coupler Connector made you enjoy your beer time. Used Place: Hex Nut Kit is used for 5/8" G Threaded Various specifications Keg Couplers and Beer Shank. The tail piece is 1/4" which can used for 3/16" beer hose. 90° Tail Piece Elbow allows the tubing to be installed more angularly and smoothly anywhere. 1/4" barb can connect the hose more firmly and hose clamps can make the pipe fully stable and not easy to cause leakage problem. Tips: Coupler connector washer and 90° tail piece elbow barb need to be replaced frequently, so as to have a clean beer hose environment and better experience. Sometimes the Beer Hose is very hard to connect, you can put the hose in the hot water, then connect the equipment. If you are not fully satisfied with Beer Keg Hex Nut Kit, please feel free to contact us, we'll help you solve it until you are satisfied.
MMIII
Reviewed in the United States on March 5, 2025
Fits fine
Big E
Reviewed in Canada on July 15, 2024
Needed these as I didn't have room for straight through connectors. They worked great and were easy to install. Docked one star as they didn't come with clamps.
mkcdl
Reviewed in the United States on May 17, 2024
I was concerned about my beer lines freezing because they were too close to the cooling air, so I purchased 2 different options in an effort to lower the lines out of the airflow. I also wanted to reorganize my lines so that it was not as quite a tangled mess with my 4 kegs in 1 frig. Both styles are in the picture and both have pros and cons. As you can see in the picture, the big pro for this 90 degree connector is that it can be directed in any direction. I set mine up so that it goes in the same direction as the CO2 hose that really help with hose organization. An additional pro is that the cost for a pair of these is about 1/3 of the low profile tap on the left. On the con side, while this connect did lower the hose a bit, it was not as much as I had hoped. Additionally, I think the size is a little off (too large). I had a real challenge getting the hose on the connector even after soaking the hose end in very hot water.
T. Castellano
Reviewed in the United States on February 19, 2024
These fit my keg perfectly and work great. they look well made and should last for many years
Don H.
Reviewed in the United States on July 13, 2023
My beer would stop coming out and I couldn't figure out why until I noticed the beer line kinked on top, so I replaced with this 90 degree fitting and now beer flows...
Michael D.
Reviewed in the United States on November 26, 2022
The barbs on these are 5/16 inch (8 mm), not 1/4 inch as advertised. I contacted the company directly through their feedback portal and haven't got a response in over a week.
V B
Reviewed in the United States on October 12, 2022
Woruu my Ed perfect on my kegerator. Not much room in the fridge when you put a whole keg in
Recommended Products
