Your cart is empty.
Your cart is empty. Product name: SAE single-head input wire (14AWG)
Specification: 2468 red and black PVC skin.
Material: new bare copper 2.03 square meters of new copper.
Voltage: 0-24V
Current: 20A
Length: 30CM
Diameter: 3.5*2mm
Input interface: 4.5mm male and female head (black wire to negative electrode, red wire to positive electrode)
Output port: 5MM tin on peeling
Weight: 28g
Much better than having to find an allen wrench to open the battery door then try to clamp those alligator clips onto the battery.
These little ring terminal harnesses are super handy to have installed on your most charged devices.
These are a must-have for old carbureted motorcycles, sticking them on my modern bikes. It is worth having one of these on every battery in your garage.
There is no need to lift the seat but still trickle charge, as you can leave it attached and tucked it in under the seat.
Use to charge battery with an accessory connector (and a USB charger) to recharge your devices, or run an air pump.
Fast and easy to connect and disconnect, you can to install on your battery for quick connection to the battery maintainer.
This is the best way to keep a battery charged on a car, or used it to keep the battery fully charged on the emergency generator.
John La SaLa
Reviewed in the United States on February 7, 2025
Thank you very hard to find.
MLee
Reviewed in the United States on August 6, 2024
My lady friend neighbor lost the clamps for her battery charger. It had two sets, one with ring terminals and one with clamps. I was tossing out a charger maintainer so I cut the clamps off, ordered these quick disconnect plugs, soldered and used heat shrink and made a nice clamp set for her charger. It seemed to be the most cost effective solution.
Customer
Reviewed in the United States on July 1, 2024
My solar panel needed an extra wiring harness and the order I placed was shipped out quickly and arrived as stated in great condition.
unit63x
Reviewed in the United States on May 15, 2024
Royal Enfield 350 has an SAE adapter for a trickle charger and this cable will allow me to use my 2 amp charger occasionally to keep the battery topped off if I go a couple weeks without riding.
Customer
Reviewed in the United States on October 12, 2024
With only 14 AWG wire, they are for lower power solar panels, but fine if you donthave to go far with them. I like 10 AWG best.
Ils0crlI
Reviewed in the United States on November 11, 2023
These are not meant to connect to each other. That are 2 of the same side. What I mean by that is you can use them as connectors with each other but one side black would be power and red would be ground. I made that mistake when I bought them. I believe they have an option you can buy legit cables that go together. Appear of quality and no issues so far.
Andy
Reviewed in the United States on August 3, 2021
The positive and negative colors don't line up with the side they should be on, but the plugs work just fine. The red should be on the "covered" side of the power supply side, and the red should be on the "exposed" side of the equipment side. These came with both the same configuration. No big deal, but just pay attention when you are installing them. ***Some things are polarity picky with using DC power, and you also don't want a "hot" terminal exposed.
june bug
Reviewed in the United States on August 30, 2020
This type of quick connect is used with a lot of low current 12 VDC devices.First off the one I got is just like the one pictured. It is for use as an in line connector. By that I mean one plug is to be hooked to the power supply. The other is hooked to the load. ( The load side connector is the one with the red wire pin fully exposed.)
Recommended Products
