Your cart is empty.
Your cart is empty.Product Description
12" (L) High Speed Steel Industrial Planer and Jointer Knives
From the Manufacturer
Freud Industrial Planer and Jointer Knives are made from premium high speed steel stock for the keenest edge and longest life. They come pre-ground to a razor sharp edge for the smoothest cut. Covered by Freud's Limited Lifetime Warranty.
David G.
Reviewed in Canada on January 10, 2025
These blades seem to be performing well, haven't sharpened yet and have been using a few years light duty use.
Kent Higgins
Reviewed in the United States on May 9, 2024
Blades fit just as original blades. Easy to install. I have used them now for about a month. Smooth surface, very sharp.
Tim S.
Reviewed in Canada on February 22, 2024
Easy install
KDF
Reviewed in the United States on March 13, 2023
The blades were sharp accurate. I bought these as a quick replacement for my ShopSmith pro planer. They are a bit longer, but fit just fine.My issue is that the metal is very soft. I had a big project and needed to plane about 500 linear feet of Poplar. I did a little over half with my old SS blades that were already getting dull.I switched to these blades and in less than 40 feet of lumber, there were hundreds of micro chips across the blades.Iām going to send them of to be sharpened and hopefully tempering will allow them to hold an edge.
MasterWolf
Reviewed in the United States on August 10, 2022
Triple check the size you need they came in a 1/8 over length but still works but check
Pam Evans
Reviewed in the United States on June 9, 2021
Great value for the money and a great finished coffee table from live edge cherry wood.
Alex Maxwell
Reviewed in the United States on March 21, 2021
Blades fit perfectly,went on without any trouble and cut beautifully! What more can you ask for?
Keith P.
Reviewed in Canada on March 1, 2020
Well packaged and properly sharpened. I installed them in my Parks planer and no adjustment needed. Excellent surface finish on planed boards as expected.
Sharron & Dave
Reviewed in the United States on January 16, 2018
Excellent fit and they seem to be holding up well to the white oak planks I have been milling.
DMAC
Reviewed in the United States on March 5, 2014
These were somewhat inexpensive, so I thought they would be scrap metal of some kind. I was wrong, they hold a good edge and last a long time between sharpening's.
WoodWiz
Reviewed in the United States on January 10, 2010
I bought these knives to replace the original set on my Shopsmith 12" Pro Planer. They fit perfectly. They are a little thicker than the original blades but they fit just fine. They came very sharp and are producing a nice clean smooth surface .The only issue I have is they had a very slight wire lip on them. I ran them across a hard arkansas stone (back side flat on the stone) to remove it.Good blades at a great price. I would buy them again.
Recommended Products