Your cart is empty.
Your cart is empty.High-performance V6 brass nozzles in different sizes for 3 mm filament
Consumer 007
Reviewed in the United States on January 25, 2023
Works great, installed perfectly without even changing the Z height. (I ran the calibration and wound up with the same Z adjustment.) Doesn't print quite as perfectly as my 0.4 but it prints much faster! Print time dropped from 3 hours 45 minutes to 1 hour 30 minutes for a part that I print often.
Christopher P.
Reviewed in the United States on February 28, 2022
It took me a while to figure out all the settings to get the most out of this larger orifice. You can't use the Prusa calibration for it. It needs more material flowing through the nozzle to speed up the printing, and I recommend using thicker layers, which greatly speeds up the print (with a little loss in detail and smoothness). Eventually, I was able to increase the print rate by about four times as fast as the nozzle that came with my Prusa Mini+ printer, without affecting the quality for the 3" x 3" x 3" terrain that I print. I use this nozzle for PETG, which can be harder to print than PLA, and this nozzle still works great after hundreds of hours of printing. I don't know when it will need to be replaced, but so far it doesn't shown any wear.
Recommended Products
